decoflame Montreal Installatiehandleiding en gebruikershandleiding - Pagina 8

Blader online of download pdf Installatiehandleiding en gebruikershandleiding voor {categorie_naam} decoflame Montreal. decoflame Montreal 12 pagina's. Custom-made bioethanol fireplaces
Ook voor decoflame Montreal: Installatiehandleiding en gebruikershandleiding (10 pagina's)

Pagina afdrukken

As the edges of the cut-out remain visible it is important that they are done to the

highest possible finish. All four corners of the cut out must have exactly a 90 degree

angle.

Plasterboard walls – Stud-walls

All surfaces inside the wall cut-out are to be covered with fibre plaster sheets or other

non-inflammable materials.

This is merely a precaution as normal plasterboard might change its characteristics

over time when exposed to heat.

Stone/Brick walls

The cut-out is made according to the attached drawing.

The wall itself is non-inflammable which makes it safe to install a bioethanol fireplace

directly in the cut-out.

8.2

Exploded view showing the installation process (see 8.2)

1. The body of the fireplace (consisting of top and sides) is positioned onto the supports left and right below and

centred within the wall cut-out. Use the enclosed screws (inserting them through the holes in the top) to secure it in

place allowing for a perfect 5mm gap all the way along the top and sides both to the front and back. Make sure that

the edges of the fireplace are kept flush with the edges of the wall cut-out.

2. The bottom of the fireplace is lowered into the recess within the wall and is placed onto the lips protruding from

the bottom of the sides. Insert the enclosed screws through the holes in the bottom plate and the holes in the lips at

the bottom of the sides (if necessary using plugs suitable for the material which has been used to create the supports)

and fix both the body and the bottom plate of the fireplace to the supports.

3. The burner is placed in the safety chamber and the sliding lid is placed on top of the burner.

3.1 Orlando Only. Secure the frame using the included screws from the inside.

4. Optional Glass. Carefully secure the glass with the 2 included finger screws.

Remember rubber seals between screw and glass.

Decoflame ApS Stenholm 14 9400 Nørresundby Denmark

[email protected]