Gantom ColorPiano Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gantom ColorPiano. Gantom ColorPiano 5 pagina's.

RECORDING A SHOW

To record a show, all you need to do is select whether you would like to record the Ambient or the

Triggered show then hit the Record button. The recording will begin as soon as you press a button on the

pallet or select a special effect. The fixture can record up to 10 minutes of show time OR 40 key presses.

Ambient show vs. Triggered show:

With Colorpiano, you have the option of using two shows, one triggered and one ambient. The ambient

show runs as soon as the light is powered on, and repeats itself continuously. The triggered show will play

when a button or trigger is pressed. If there is an ambient show playing, the triggered show will interrupt

it and begin playing. When the triggered show is complete, the light will begin playing its ambient show

on loop again.

Making a simple trigger:

The light will play its triggered show when the TIP and SLEEVE of an audio cable that are connected to it

are shorted together.

A simpler way to do to do this is to cut the TRS connector off of an audio cable. This will leave you with 3

wires: Red, Green (or blue), and Black. You will then need to connect these wires to an NO (Normally

Open) Momentary Button like the one pictured above. On one of the poles you will need to connect the

Red and Green (or blue) wire. On the other pole you will need to connect the Black wire. The button

should now trigger the ColorPiano show when it is pressed. Please note that the wire colors for your audio

cable may be different from this guide.

ColorPiano User Guide

Version 1.0 – 11/29/2016