IKEA IH6242WM0 Installatie-instructies en gebruiks- en onderhoudshandleiding - Pagina 10
Blader online of download pdf Installatie-instructies en gebruiks- en onderhoudshandleiding voor {categorie_naam} IKEA IH6242WM0. IKEA IH6242WM0 28 pagina's. 60 cm (23 3/5") wall-mount canopy range hood
Pagina afdrukken
1,
For non-vented (recirculating installations,
install charcoal
filter over grille on blower housing and turn filter handle
clockwise.
Repeat with other charcoal filter.
.......................
C
A. Blower housing
B. Filter handle
C. Charcoal filters
2. For all installations,
insert back edge or metal filter into rear
channel of the filter opening.
3. Push handle toward the rear and push filter up.
4. Pull filter toward the front and insert into front channel.
q|
A
B
...... _ o1_ ®0123 {_
.....
A. Light switch
B. Blower switch
1. Move the light switch to "1" position. The light should turn on.
2. Move blower switch to "1" position. The blower should
operate.
3. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
4. Move blower and light switches to "0" position to turn off
blower and light.
5. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
6. Disconnect
power supply.
7. Check that the wiring is correct.
8. Replace all parts and panels before operating.
9. Reconnect power.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
RANGE HOOD USE
The canopy hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Hood control panel
The hood controls are located on the front side of the canopy.
........ S
Operating
the light
1. Move the light switch to the "1" position to turn on the light.
2. Move the light switch to the "0" position to turn off the light.
Operating
the blower and adjusting
blower speed
1. Move the blower switch to the "1" position for low speed, the
"2" position for medium speed or the "3" position for high
speed.
2. Move the blower switch to the "0" position to turn off the
blower.
A. Light switch
B. Blower switch
10