IKEA IHW7302YS0 Gebruiks- en onderhoudshandleiding - Pagina 12

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} IKEA IHW7302YS0. IKEA IHW7302YS0 44 pagina's. 30"(76.2cm) wall-mount canopy range hood

Pagina afdrukken

RANGE HOOD CARE

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning

Method:

•

Liquid detergent soap and water, or all-purpose

cleanser

•

Wipe with damp soft cloth or nonabrasive sponge, then rinse

with clean water and wipe dry.

Metal Grease Filter:

1. Remove each filter by pulling the spring release handle and

then pulling down the filter.

................

A. Spring release handle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.

Non-Vented

(recirculating)

Installation

Filters:

The charcoal filter is not washable. It should last up to 6 months

with normal use. Replace with Charcoal Filter Kit. See the

"Assistance

or Service" section for information on ordering.

To replace

charcoal

filter:

1. Remove metal grease filter from range hood. See "Metal

Grease Filter" in this section.

2. Bend spring clips away from metal grease filter.

3. Place charcoal filter into top side of metal filter.

4. Bend spring clips back into place to secure the charcoal filter

to the metal filter.

5. Replace metal grease filter. See "Metal Grease Filter" in this

section.

Replacing

a Halogen

Lamp

Turn off the range hood and allow the halogen lamp to cool. To

avoid damage or decreasing the life of the new lamp, do not

touch lamp with bare fingers. Replace lamp, using tissue or

wearing cotton gloves to handle lamp.

If new lights do not operate, make sure the lamps are inserted

correctly before calling service.

1. Disconnect

power.

2. Use a flat-blade screwdriver and gently pry the light cover

loose.

3. Remove the lamp and replace with a 12-volt, 20-watt

maximum, halogen lamp made for a G-4 base.

4. Replace the light cover.

5. Reconnect power.