Avantco 178UBB3HC Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Avantco 178UBB3HC. Avantco 178UBB3HC 11 pagina's. Back bar refrigerator
Ook voor Avantco 178UBB3HC: Gebruikershandleiding (7 pagina's), Gebruikershandleiding (7 pagina's)

Pagina afdrukken

User Manual

Back Bar Refrigerators

Troubleshooting

Problem

Possible Solution

Fuse blown or circuit breaker tripped

Replace fuse or reset circuit breaker

Power cord unplugged

Plug in power cord

Compressor is

Not Running

Thermostat set too high

Set thermostat to lower temperature

Cabinet in defrost cycle

Wait for defrost cycle to finish

Thermostat is set too high

Set thermostat to lower temperature

Airflow is blocked

Re-arrange products to allow for proper airflow

Make sure there is at least four inches of clearance from the evaporator

Excessive amount of warm product placed in cabinet

Allow adequate time for product to cool down

Cabinet Temperature

is too Warm

Fuse blown or circuit breaker tripped

Replace fuse or reset circuit breaker

Low refrigerant levels

Clean the condenser coil

Prolonged door opening or door ajar

Ensure doors are closed when not in use

Avoid opening doors for long periods of time

Excessive amount of warm product placed in cabinet

Allow adequate time for product to cool down

Prolonged door opening or door ajar

Ensure doors are closed when not in use

Avoid opening doors for long periods of time

Door gasket(s) not sealing properly

Condensing Units Run

Ensure gaskets are snapped in completely

for Long Periods of Time

Remove gasket and replace if necessary

Dirty condenser coil

Clean the condenser coil

Evaporator coil iced over

Unplug unit and allow coil to defrost

Make sure thermostat is not set too cold

Ensure that door gasket(s) are sealing properly