KitchenAid KD-27A SERIES Handleiding voor installatie-instructies - Pagina 12

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid KD-27A SERIES. KitchenAid KD-27A SERIES 16 pagina's.

7
FlNAL CHECK LIST
Open the dishwasher door and remove all cardboard, and literature. DO NOT remove the white plastic plug buttons
(Fig. 17) from sides of door or the white plastic bumpers on front corners of the lower rack. DO NCrr remove the
two spring retainers (Fig. 18) attached to the tank water heater if dishwasher
is so equipped.
Fig.
17
Fig.
18
Turn on the electrical
power supply.
Test dishwasher
operation:
1.
Push buffon
models - Close and latch the door. Press Cancel Cycle button, timer will automatically
advance
to off. Lift the door handle and allow several seconds for the timer to reset. Latch the door handle, press Normal
Wash button, and allow the dishwasher
to run through a complete cycle,
2.
Cycle Selection
Dial Models - Close and latch the door. Turn the dial clockwise until it clicks into the Normal
Wash position. Press Start or Normal Wash button and allow the dishwasher to run through a complete cycle.
3.
Solid State Models
-
Close and latch door. PF appears in display. Press Cancel
Turn off the electrical power and check for leaks
under the dishwasher.
Make sure that no kinks
have developed
in the fill or drain lines.
The lower panel and adjustable kickboard (Fig. 19)
must be replaced. Line up panel flanges (3) to fit
under lip of channel
(4). Slide panel up until it
stops and then push up tabs (2) to hook over the
frame. Secure the lower panel with two screws (1).
Replace the kickboard using two screws (one with
lock washer). Check to assure that the opening
at the bottom of the kickboard is not obstructed
(e.g., by carpet, molding, etc.). This area must be
open to provide air circulation
to cool the motor.
This completes dishwasher installation. For more
information
about the dishwasher,
please refer
to your Use and Care Guide.
-
12 -