Ganz PixelPro GXi Series Installatiehandleiding - Pagina 13

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Ganz PixelPro GXi Series. Ganz PixelPro GXi Series 18 pagina's. H.264 video encoder

Pagina afdrukken

PixelPro GXi Series

5.2.2. View video using IP address

View the live video on a web page using your IP device and its IP address. To have the correct

IP address ready and use it on a web page:

1. Convert a MAC address to an IP address or check the IP address on the IPAdminTool. Refer to

Appendix (C): Hexadecimal-Decimal Conversion Table.

(The MAC address is attached on the side or bottom of the device.)

MAC address =

Convert the last two sets of hexadecimal numbers to decimal numbers.

2. Open a web browser and enter the IP address of the device.

3. Click pop-up blocked and install the ActiveX setup.exe by clicking the Run or Save button.

You need to install the ActiveX for displaying the images.

4. Follow the instructions of the dialog boxes and complete the installation. Then the live video

is displayed on the main page of the web browser.

5.3. Reboot

1. While the device is in use, press and hold the Reset button.

2. Release the Reset button after 2 seconds.

3. Wait for the system to reboot.

5.4. Factory Default

Resetting the device back to the factory default will initialize all parameters including the IP

address back to the factory defaults. To reset to the factory default:

1. While the device is in use, press and hold the reset button for about 10 seconds.

(LED blinks when the device is restored to factory default status.)

2. Wait for the system to reboot.

The factory default settings can be inferred as follows:

IP address:

Network mask:

Gateway:

Note

User ID:

Password:

10-2013-A

00-1C-B8-01-23-45 →

192.168.xx.yy

255.255.0.0

192.168.0.1

root

pass

ZS1-4DB1 Installation Guide

IP address =

192.168.35.69