HIKVISION DS 7204HQHI K1/B Snelstarthandleiding - Pagina 6
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} HIKVISION DS 7204HQHI K1/B. HIKVISION DS 7204HQHI K1/B 15 pagina's.
Pagina afdrukken
The rear panel interfaces vary according to different models. Refer to Table 1-1 for the common interfaces description.
Item
Description
BNC interface for Turbo HD and
VIDEO IN
analog video input
AUDIO IN
RCA connector for audio input
RCA connector for two-way audio
LINE IN
input
DB15 connector for local video output
VGA
and menu display
RS-485 serial interface for pan/tilt
RS-485
unit, speed dome, etc
LAN
RJ-45 self-adaptive Ethernet interface
ALARM IN/OUT
Alarm input/output interface
Power Switch
Switch for turning on/off the device
DVR Installation
During installation of the DVR:
Use brackets for rack mounting.
Ensure ample room for audio and video cables.
When routing cables, ensure the bend radius of the cables are no less than five times of its diameter.
Allow at least 2 cm (≈0.75 inch) of space among racks mounted devices.
Ensure the DVR is grounded.
Environmental temperature should be within the range of -10 °C to 55 °C (14 °F to 131 °F).
Environmental humidity should be within the range of 10% to 90%.
HDD Installation
Before you start
Ensure power is disconnected.
Prepare a factory recommended HDD, and cross screwdriver.
Bracket Installation
Bracket installation is applicable when it requires to remove the device cover, and install HDD on the internal bracket.
Unfasten screws on the back, and push the cover backwards to remove the cover. Refer to Figure 2-1.
Fix the HDD on the bracket with screws. Refer to Figure 2-2.
Please uninstall the upper layer bracket first before installing HDD on the lower layer bracket.
Connect the data cable and power cable. Refer to Figure 2-3.
You can repeat the steps above to install other HDDs.
Reinstall the device cover and fasten screws.
Remove Cover
Digital Video Recorder Quick Start Guide
Chapter 1 Rear Panel Interfaces Description
Common Interfaces Description of Rear Panel
Chapter 2 Installation and Connections
Item
Description
VIDEO OUT
BNC connector for video output
AUDIO OUT
RCA connector for audio output
Universal Serial Bus (USB) interface for
USB
additional device
HDMI
HDMI interface for video output
RS-232 interface for parameter configuration,
RS-232
or transparent channel
Storage and expansion interface for record or
eSATA
backup
GND
Ground
100 to 240 VAC, 48 VDC, or 12 VDC power
Power Supply
supply, different models vary
Fix HDD
5
Connect Cable