KitchenAid KUDD01DPPA0 Handleiding voor installatie-instructies - Pagina 6
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid KUDD01DPPA0. KitchenAid KUDD01DPPA0 16 pagina's. Drawer dishwasher
Pagina afdrukken
4, Asthedishwasher
isbeing pushed i ntotheopening, slowly
pull t heinlet h ose, drain hoses a ndpower supply c ord
through t heutility hole.
5, Remove thestrap from upper drawer.
Goto"IfInstalling Flexible Trim Pieces" section.
Option2: DirectWiringMethod
E_ectrical Shock Hazard
Disconnect
electrica_ power at the fuse box or circuit
breaker box before installing
dishwasher.
Failure to do so can result in death or e_ectrical shock.
6, Rotate drawer to the right onto its side and place on the
protective cover.
(--
\
"J
I
electrical cover
7, Slide the left-hand runner back into the dishwasher.
8, The electrical cover is located in the back Ieft corner.
Use a flat blade screwdriver to press the release button. Slide
the cover to the right and then pull up.
1, Place cardboard or other protective covering on the floor in
front of cabinet opening. Place the dishwasher on covering.
2, Disconnect power.
3, Open the bottom drawer.
4, Press in the right-hand runner clip and push it back about 6"
(15.2 cm). Repeat with the left-hand runner clip.
NOTE: When removing the drawer there is limited range of
movement due to the attached water hoses.
5,
runner clip
Lift the right edge of the drawer off its runner. Slide that runner
back into the dishwasher. Lift the drawer completely off the
left-hand runner.
j,_
,,
i
i
press
release button
Remove factory-installed
power cord,
1, Disconnect the black and white wires of the power cord from
the terminal block.
strain relief
terminal block
green ground screw
2, Use a 7 mm socket wrench to remove the green ground
screw. Remove the green ground wire.
3, Use a Phillips screwdriver to remove the strain relief screw.
Open the strain relief.
4, Pull the power supply cord off the dishwasher through the
back of the dishwasher.
5, Close the strain relief and replace screw so it does not
interfere with the electrical cover.