IKEA IWM60 Gebruikershandleiding - Pagina 20

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} IKEA IWM60. IKEA IWM60 28 pagina's. Clothes washer
Ook voor IKEA IWM60: Gebruikershandleiding (5 pagina's), Gebruikershandleiding (24 pagina's), Gebruiksaanwijzing (20 pagina's), Handmatig (20 pagina's)

Pagina afdrukken

ENGLISH

• Screw the water inlet hose back on and

reposition the emergency emptying hose

after having put the cap on again.

• When you intend to start the appliance

up again, make sure that the room tem-

perature is above 0°C.

Important! Every time you drain the water

through the emergency emptying hose you

must pour 2 litres of water into the main

wash compartment of the detergent drawer

and then run the drain programme. This will

activate the ECO VALVE device avoiding

that part of the detergent remains unused

at next washing.

Emergency emptying out

If the water is not discharged, proceed as

follows to empty out the appliance:

Troubleshooting

The appliance does not start or stops during

operation. It is possible that the red indica-

tor light of button 4 blinks to indicate that

the appliance is not working.

Problem

Possible cause

The door has not been closed (The

red indicator light of button 4

blinks).

The plug is not properly inserted in

the power socket.

There is no power at the socket.

The appliance

does not start:

The main fuse has blown.

The programme selector dial is not

correctly positioned and the button

4 has not been pressed.

The delay start has been selected.

The water tap is closed The red in-

dicator light of button 4 blinks).

The appliance

The inlet hose is squashed or

does not fill:

kinked (The red indicator light of

button 4 blinks).

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has

cooled down;

• open the pump door;

• place a bowl on the floor and place the

end of the emergency emptying hose into

the bowl. Remove its cap. The water

should drain by gravity into the bowl.

When the bowl is full, put the cap back

on the hose. Empty the bowl. Repeat the

procedure until water stops flowing out;

• clean the pump if necessary as previously

described;

• replace the emergency emptying hose in

its seat after having plugged it;

• screw the pump cover again and close

the door.

Before contacting your local Service Centre,

please carry out the checks listed below.

Solution

Close the door firmly.

Insert the plug into the power

socket.

Please check your domestic electri-

cal installation.

Replace the fuse.

Please turn the selector dial and

press the button 4 again.

If the laundry are to be washed

immediately, cancel the delay

start.

Open the water tap.

Check the inlet hose connection.