IKEA RENGJORD Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} IKEA RENGJORD. IKEA RENGJORD 23 pagina's.
Ook voor IKEA RENGJORD: Montagehandleiding (40 pagina's)

Pagina afdrukken

CONTROLS & SETTINGS



NOTE

The dishwasher checks the soil level on your dishes. In response, automatic cycle adjust-

ments are made to assure the dishwasher gets clean – with less food the cycle gets shorter.

Cycle time will also vary based on the options selected and the incoming water temperature.

CAUTION

Property Damage Hazard

Before starting dishwasher be sure that

the water is connected and turned on.

Failure to do so may cause damage to the

pump seal and result in water leakage.

Wash Cycle Selections

Cycle times are approximate and will

vary with options selected. Hot water is

necessary to activate dishwasher detergent

and melt fatty food soils. An automatic

sensor will check the incoming water

temperature and, if it is not hot enough, the

cycle will be lengthened for automatic water

heating in the main wash and final rinse of

all cycles. This happens even when HI-TEMP

WASH option has not be selected. When

HI-TEMP WASH is selected, an even higher

temperature will be reached to handle

heavier soil loads.

Recommended Cycle for typical use:

The Normal cycle with its factory default

options of normal temperature and

heated dry together provide the best all

around performance. This cycle selection

is recommended for everyday use and is

suitable for a large range of both dish load

sizes and food quantities remaining on those

dishes.

Option Selections

Wash Pressure

The programmed cycles default to the

"surge" pressure option which varies the

pressure optimally for the cycle's intended

normal use. If a very low "spray" is desired,

press the WASH PRESSURE button. Due to

wash cycle optimization, some pressure

options are not selectable in all wash cycle.

Wash Temp

The programmed cycles default to the

"normal" temperature option, to choose HI-

TEMP or SANITIZE press WASH TEMP button

again.

Hi-Temp Wash Option

HI-TEMP WASH option is selected, by

pressing the WASH TEMP button. The

dishwasher heats water in the main wash

to approximately 140°F (60°C) and increases

the temperature higher in the final rinse to

help with the drying stage.

This helps dishwasher detergent remove

food grease and soil from dishes more

effectively and aids in drying performance

by adding additional rinse aid and

increasing the water temperature.

Sanitize Option

To sanitize your dishes and glassware, select

SANITIZE option, by pressing WASH TEMP

button. When selected, the light will come

on and remain on until end of cycle. The

water temperature in the final rinse will

be raised to 155°F (68°C) and will maintain

that temperature for 9 minutes. This option

is available in Heavy and Normal Cycles.

Only these sanitization cycles have been

designed to meet NSF requirements.

The cycle time will be extended until the

proper water temperature is reached.

Washing action will continue during the

water heating delay. For best results, the

incoming water temperature should be at

least 120°F (49°C).

The sanitize criteria may not be satisfied if

there is an interruption of the cycle, power

failure or if the incoming water temperature

is below 120°F (49°C).

To turn off the SANITIZE option, press the

Wash Temp button. The SANITIZE light will

turn off.