IKEA RENLIG Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} IKEA RENLIG. IKEA RENLIG 42 pagina's. Integrated dishwasher
Ook voor IKEA RENLIG: Gebruikershandleiding (28 pagina's), Gebruikershandleiding (18 pagina's), Handmatig (32 pagina's), Gebruiksaanwijzing (32 pagina's), Handmatig (20 pagina's)

Pagina afdrukken

Add Rinse Aid

Your dishwasher is designed to use rinse aid for good drying

performance. Without rinse aid your dishes and dishwasher

interior will have excessive moisture. The heat dry option will

not perform as well without rinse aid.

Rinse aid keeps water from forming droplets that can

dry as spots or streaks. They also improve drying by

allowing water to drain off of the dishes after the final

rinse.

Rinse aid helps to reduce excess moisture on the

dish racks and interior of your dishwasher.

Check the rinse aid indicator. Add rinse aid when indicator

drops to "Refill" level.

To add rinse aid, turn the

dispenser cap ¼ turn

counterclockwise and lift

off. Pour rinse aid into the

opening until the indicator

level is at "Full." Replace

the dispenser cap and turn

to "Lock." Make sure cap is

fully locked.

NOTE: For most water conditions, the factory

setting will give good results. If you have hard

water or notice rings or spots, try a higher

setting. Turn the arrow adjuster inside the

dispenser to change rinse aid settings.

If you are experiencing poor dry

performance, you may want to try a higher

setting in your rinse aid dispenser.

Select a Cycle (cycles vary by model)

Press and hold the desired cycle button until the corresponding

light is on. See "Cycle and Option Descriptions" charts in the

following section.

NOTE: Heavier cycles and options affect cycle length. Some

cycles and options will take up to 3¹⁄₂ hours to complete.

Select Options (options vary by model)

You can customize your cycles by pressing the options desired.

STEP 3

Start or Resume a Cycle

Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water.

Full

If the Start/Resume button is located on

top of door, push door firmly closed within

3 seconds of pressing START/RESUME. If

door is not closed within 3 seconds, the

start button LED will flash, an audible tone

Add

will be heard, and cycle will not start.

IMPORTANT: If anyone opens the door (such as, for adding a dish,

even during the Delay Hours option), the START/RESUME button

must be pressed each time.

If your Start/Resume button is located on front of door, push

door firmly closed. The door latches automatically. Select the

wash cycle, options and press START/RESUME or press

START/RESUME to repeat the same cycle and options as in

previous wash cycle.

You can add an item anytime before the main wash starts.

Open the door slowly and add the item. Close the door firmly.

Press START/RESUME.

The Complete indicator glows when the cycle is finished.

Sanitized glows when Sani Rinse option is selected and

sanitization levels occur.

STEP 4