HIKVISION DS-7108HQHI-K1 Snelstarthandleiding - Pagina 8
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} HIKVISION DS-7108HQHI-K1. HIKVISION DS-7108HQHI-K1 17 pagina's. Network/digital video recorder
Ook voor HIKVISION DS-7108HQHI-K1: Snelstarthandleiding (17 pagina's), Snelstarthandleiding (8 pagina's)
Pagina afdrukken
Fix-on-Bottom Installation
Fix-on-bottom installation is applicable when it requires to install the HDD at the internal bottom.
Unfasten screws on each panel to remove the device cover. Refer to Figure 2-7.
Connect the data cable and power cable. Refer to Figure 2-8.
Match HDD screw threads with the reserved holes on the device bottom, and fix HDD with screws. Refer
to Figure 2-9.
You can repeat the steps above to install other HDDs.
Reinstall the device cover and fasten screws.
RS-485 and Controller Connection
Use RS- 485 interface to connect PTZ with DVR.
Before you start
Ensure both controller and DVR are grounded.
Pull out the pluggable block at the RS-485 terminal block.
Press and hold the orange part of the pluggable block, insert signal cables into slots.
Release the orange part. Ensure signal cables are in tight.
Connect A+ on PTZ to D+ on terminal block and B- on controller to D- on terminal block. Fasten stop
screws.
Plug pluggable block back into terminal block.
Digital Video Recorder Quick Start Guide
Fix Mounting Ear
Remove Cover
Open Front Panel
Connect Cable
7
Insert HDD
Fix HDD