Makita 3600H Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 3600H. Makita 3600H 12 pagina's.

Pagina afdrukken
1
2
3
4
005032
To install the straight guide, insert the guide bar into the
holes in the tool base until the notch in the guide bar
reaches just under the wing bolt (B). Then tighten wing
bolt (B). Loosen the wing bolt (A) and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing bolt (A) to secure the
straight guide in place.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Templet guide
005033
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, screw the templet guide on
the base plate.
1
005034
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1. Wing bolt (B)
2. Guide bar
3. Wing bolt (A)
4. Straight guide
1. Template guide
2. Base plate
2
1
2
3
4
5
6
003695
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Trimmer guide
005035
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
1
2
3
4
5
005036
Install the trimmer guide on the tool base with the wing
bolts (B). Loosen the wing bolt (A) and adjust the
distance between the bit and the trimmer guide by
turning the fine adjusting screw (1.5 mm per turn). At the
desired distance, tighten the wing bolt (A) to secure the
trimmer guide in place. When adjusting the guide roller
up or down, loosen the wing bolt (C). After adjusting it,
tighten the wing bolt (C) securely.
6
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide
1. Wing bolt (B)
2. When the bit
strikes the
trimmer guide,
insert a piece of
wood into this
space.
3. Fine adjusting
screw
4. Wing bolt (A)
5. Trimmer guide
6
6. Guide roller
7
7. Wing bolt (C)