Makita 3707F Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 3707F. Makita 3707F 17 pagina's. Trimmer
Ook voor Makita 3707F: Specificaties (2 pagina's), Gebruiksaanwijzing (16 pagina's), Gebruiksaanwijzing (10 pagina's), Gebruiksaanwijzing (13 pagina's)

Pagina afdrukken

1. Feed direction

2. Bit revolving direction

3. Workpiece

4. Trimmer shoe, straight guide

1. Screws

2. Base protector

3. Screwdriver

4. Screws

10mm(3/8")

1. Straight bit

2. Base

3. Templet

4. Distance (X)

5. Workpiece

6. Templet guide 10

•

When using the trimmer shoe, the straight guide or the

001985

trimmer guide, be sure to keep it on the right side in the

feed direction. This will help to keep it flush with the side

of the workpiece.

CAUTION:

•

Since excessive cutting may cause overload of the motor

or difficulty in controlling the tool, the depth of cut should

not be more than 3 mm (1/8") at a pass when cutting

grooves. When you wish to cut grooves more than 3 mm

(1/8") deep, make several passes with progressively

deeper bit settings.

Templet guide

001986

The templet guide provides a sleeve through which the bit

passes, allowing use of the trimmer with templet patterns.

Loosen the screws and remove the base protector. Place the

001987

templet guide on the base and replace the base protector.

Then secure the base protector by tightening the screws.

Secure the templet to the workpiece. Place the tool on the

001988

templet and move the tool with the templet guide sliding

along the side of the templet.

NOTE:

•

The workpiece will be cut a slightly different size from the

templet. Allow for the distance (X) between the router bit

and the outside of the templet guide. The distance (X)

can be calculated by using the following equation:

Distance (X) = (outside diameter of the templet guide - router

bit diameter) / 2