Makita 3708FC Gebruiksaanwijzing - Pagina 8
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 3708FC. Makita 3708FC 16 pagina's. Trimmer
Ook voor Makita 3708FC: Specificaties (2 pagina's), Onderdelenlijst (3 pagina's), Opsplitsing onderdelen (3 pagina's), Gebruiksaanwijzing (12 pagina's)
Pagina afdrukken
1
2
3
4
001990
Loosen the wing nut and secure the tool base
horizontally.
1
2
5
002008
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a straight
board to the workpiece and use it as a guide against the
trimmer base. Feed the tool in the direction of the arrow.
A
002009
Circular work
1
4
5
001993
1. Bolt
2. Guide plate
3. Straight guide
4. Wing nut
1. Clamp screw (A)
2. Straight guide
3. Wing bolt
3
4. Base
5. Wing nut
4
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows:
Min.: 70 mm
Max.: 221 mm
For cutting circles between 70 mm and 121 mm in radius.
For cutting circles between 121 mm and 221 mm in
radius.
1
4
5
001994
NOTE:
Circles between 172 mm and 186 mm in radius
•
cannot be cut using this guide.
Align the center hole in the straight guide with the center
of the circle to be cut. Drive a nail less than 6 mm in
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
002010
Trimmer guide
002011
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The guide
roller rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base
horizontally.
8
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
1. Nail
2. Center hole
1
3. Straight guide
2
3