Makita 4131 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 4131. Makita 4131 12 pagina's. Metal cutter
Ook voor Makita 4131: Gebruiksaanwijzing (14 pagina's), Gebruiksaanwijzing (12 pagina's), Gebruiksaanwijzing (12 pagina's), Gebruiksaanwijzing (12 pagina's)

Pagina afdrukken
Makita 4131 Gebruiksaanwijzing
1
1. Rip fence(Guide rule)
2. Screw

OPERATION

1. Carbide-tipped saw blade
2. Workpiece
1
1. Sight window
2. Workpiece
1
1. Retracting lever
8
Rip fence (guide rule) (Accessory)
005351
The handy rip fence (guide rule) allows you to do extra-accurate straight cuts.
Simply slide the rip fence up snugly against the side of the workpiece and
2
secure it in position with the clamp screw on the front of the base. It also
makes repeated cuts of uniform width possible.
005352
CAUTION:
2
•
Never twist or force the tool in the cut. This may cause motor overload
and/or a dangerous kickback, resulting in serious injury to the operator.
Hold the tool firmly with both hand. Set the base plate on the workpiece to be
cut without the blade making any contact. Then turn the tool on and wait until
the blade attains full speed. Move the tool forward over the workpiece surface,
keeping it flat and advancing smoothly until the cutting is completed. Keep
1
your cutting line straight and your speed of advance uniform.
The sight window in the base makes it easy to check the distance between the
005353
front edge of the saw blade and the workpiece whenever the blade is set to the
maximum depth of cut.
2
005354
NOTE:
•
When making a miter cuts etc., sometimes the lower guard does not
move easily. At that time, use the retracting lever to raise the lower guard
for starting cut and as soon as blade enters the material, release the
retracting lever.
CAUTION:
•
Do not use a deformed or cracked blade. Replace it with a new one.
•
Do not stack materials when cutting them.
•
Do not cut hardened steel, stainless steel, aluminum, wood, plastics,
concrete, tile, etc. Cut only mild steel.
•
Do not touch the saw blade, workpiece or cutting chips with your bare
hand immediately after cutting, they may be extremely hot and could
burn your skin.