Avantco Equipment 177PC201 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Avantco Equipment 177PC201. Avantco Equipment 177PC201 9 pagina's. Electric countertop pasta cooker/rethermalizer with water refill, drain, and overflow feature
Pagina afdrukken
Operation
WARNING!
This equipment must be operated by trained professionals. Please ensure all parts are cleaned thoroughly
before use. Please see Safety section.
CAUTION:
Heating element must remain in a flat position. Water must completely cover the heating element, at least
to the MIN water level. Plug in the socket, and turn dial to switch the pasta cooker/rethermalizer ON.
IMPORTANT:
Continually observe and maintain water level in the basin. Water level will decrease with each boil. Refill
with fresh water as needed
1.
Please make sure the power supply you are using is adequate for continual cooking use and voltage is adequate.
The use of a surge protector or circuit breaker is advisable.
2.
DO NOT overload the pasta cooker/rethermalizer with water or food product. Water will splatter, causing serious
injuries and burns.
3.
Use caution when adding pasta into the baskets.
4.
Always use extreme caution when lowering, lifting and draining baskets. The water is extremely hot.
Water Connection
1.
Place machine on sturdy, level, heat resistant, non-flammable surface near power supply and water supply.
2.
Using a ¾" high pressure flexible hose (not included), connect the water supply to the inlet (refill) valve located on
the back of the pasta cooker/rethermalizer.
3.
This pasta cooker/rethermalizer comes equipped with a ¾" water inlet connection requiring 30-80psi inlet pressure.
Recommended Plumbing Connection Setup (Not Required)
1.
Form three coils of ¼" O.D. copper tubing or high pressure flexible hose (not supplied) and connect to the cold
waterline. The coils allow the dispenser to be moved easily for cleaning and servicing.
2.
Flush incoming water in the line.
3.
It is recommended that an optional shut off valve and water filter be installed on the water line at this time.
4.
3. Attach the water line to the water inlet fitting located on the rear of the machine. Hold the machine water inlet
fitting with a wrench when tightening the water line.
5.
Check for water leaks at water inlet. Tighten fittings if necessary.
www.AvantcoEquipment.com
User Manual
(Fig. 1)
5