GarageAce S3 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} GarageAce S3. GarageAce S3 16 pagina's.

Pagina afdrukken
4.

Adjustment instructions

Open the cover as shown in Fig16 showing before adjusting.

4.1. Ready status

After switching on the power, the LED lights
will turn on for 2 seconds and off. Then the opener
enters ready status, the LED flashes slowly showing the
door body's position. As Fig17 shows, from left
to right, they are representing opening limit
position, middle position, and closing limit position.
4.2. Operation instruction
When the transmitters are programmed as a two-button
control, press the open-button to open the door, press the close-button
to close the door. If the door is moving, press any button to stop the door.
When the transmitters are programmed into one-button control, only the button which
was used when learning the transmitter works, and it can open, close and stop the door.
The "+" button on the opener can also work as a push button. It can open, close and
stop the door. Pressing the "-"button can turn the courtesy lights on or off.

4.3. Adjusting methods

4.3.1. Enter the adjusting status
In the ready status, press the "P" button until the LED shows the picture as Fig18 shows,
then release the button.
4.3.2. Auto detect
Press "+", the lamp begins to flash, the Opener goes toward the opening
direction automatically stops at the mechanical open limit position.
It will then automatically move toward the closing position and stop at the close position.
When the lamp stops flashing, the auto detect procedure is finished and it exits the setting
status automatically. After the auto detecting procedure, the garage door can be used
normally.
During the auto detect, when the door is fully closed, pressing the "-" button will stop the
opener moving and will set the close position at that point.
Notice:
A)
Before going into auto detect mode, please ensure the open door limit bracket is installed at the opener
guiding rail according to the maximum open height as step 3.6.
B)
If the photo beam is equipped, please finish installing the photo beam before Auto detect mode.
C)
Please ensure no people, pets or items are in way of the door during auto detect mode.
4.3.3.
Reducing gaps
Press the "P" button until LED shows as Fig19. Pressing "+" and "-" will
adjust the gaps. After adjustment, just press "P" to confirm. If you
needn't change the value, directly press "P", the system will automatically
enter into next step.
Values: 0 ~ 9 - each increase or deduction of value means the gap
increases or deducts 5mm.
6
Figure 16
Figure 17
Figure 18
Figure 19