CORNING SCRN-510 Hardware installatiehandleiding - Pagina 8

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} CORNING SCRN-510. CORNING SCRN-510 17 pagina's. Small cell radio node

Pagina afdrukken

Connectors, SFP+ and Micro-USB Ports, and Status LED

The radio node has the following connectors and a small form-factor pluggable SFP+ port, as shown in

Figure

4.1

Duplex Phoenix Power Cable Ports

The SCRN-510 has two 48 VDC power connectors for delivering power from a Corning PSU6 DC Power Supply

Unit or equivalent to the radio node. Plug the Phoenix power connectors from the power source cable into the

power connectors; one connector into the PRIMARY port, and then another connector into the SECONDARY

port. Both ports must be provided with power.

4.2

SFP+ Transceiver Port

The enhanced small form-factor pluggable (SFP+) is a compact, hot-pluggable network interface module. The

approved SFP+ included on the Bill Of Materials supports 10 GbE (Gigabit Ethernet). Connect the fiber pair of

the ActiFi cable (or other approved fiber cable) with approved SFP module termination to the SFP port for con-

necting the radio node to the fronthaul transport network.

4.3

Micro-USB Port

The Micro-USB port is used for advanced configuration. For use only by authorized technicians.

4.4

Status LED

The STA (status) RGB tri-color LED indicates the state of the SCRN-510, with boot, normal, disabled, fault, and

radio node indications. When the radio node initially boots, the LED cycles through a number of colors and

flashing behaviors until the SCRN-510 is fully operational.

describes the STA LED indications.

Corning Restricted and Confidential Proprietary - Controlled content

SCRN-510 Hardware Installation Guide | DOC-SCRN-510-HIG_i4 | 16 October, 2020 | Page 8

Figure 4

SCRN-510 Connectors and Status LED

Section 11., Radio Node LED Boot Sequence