CORNING CWDM MUX Beknopte handleiding - Pagina 2

Blader online of download pdf Beknopte handleiding voor {categorie_naam} CORNING CWDM MUX. CORNING CWDM MUX 2 pagina's. Enhanced management

Pagina afdrukken

Connect Jumpers to CWDM Modules

Step 1:

Pull module out to detent position (Figure 3).

Step 2:

Press buttons on each side of the module (Figure 4) and lower the handle.

KPA-2134

Step 3:

Remove dust caps and clean adapters and connectors per standard company practice.

Step 4:

Refer to the designation label (Figure 2) on the handle of the module for the port

designations to determine where your jumpers should be connected.

NOTE: The first port on the left is empty and not available for use.

•

Connect the common port jumper to the port labeled "COM."

•

Connect the remaining jumpers to the applicable port with the desired wavelength as

shown on the designation label.

•

To monitor the module, insert a test jumper into the port labeled "MON."

Step 5:

Connect jumpers (Figure 5) as required.

Step 6:

Raise handle. Dress jumper cords (Figure 6) to the side of the module.

KPA-2136

Step 7:

Push module back into the housing and dress jumper cords in frame as described in the

installation instruction provided with the housing.

IMPORTANT:

Corning Cable Systems LLC √ PO Box 489 √ Hickory, NC 28603-0489 USA

1-800-743-2671 √ FAX +1-828-325-5060 √ International +1-828-901-5000 √ http://www.corning.com/cablesystems

Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems' products without prior notification.

All trademarks are the properties of their respective owners. Corning Cable Systems is ISO 9001 certified.

STANDARD RECOMMENDED PROCEDURE 003-787 | ISSUE 1 | AUGUST 2008 | PAGE 2 OF 2

Figure 3 — Pull Module Out

Figure 5 — Connect Jumpers

Guide fibers while inserting module to avoid pinching fibers.

Button

KPA-2135

KPA-2137

Figure 6 — Dress Jumper Cords

Figure 4 — Lower Handle