Makita 5603R Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 5603R. Makita 5603R 13 pagina's. 165/190/235 mm
Ook voor Makita 5603R: Handmatig (15 pagina's), Gebruiksaanwijzing (13 pagina's), Gebruiksaanwijzing (13 pagina's), Gebruiksaanwijzing (12 pagina's), Gebruiksaanwijzing (13 pagina's), Gebruiksaanwijzing (16 pagina's)

Pagina afdrukken

9. Use Rip Fence.

Always use a fence or straight edge guide

when ripping.

10. Guard Against Kickback.

Kickback occurs when the saw stalls rapidly

and is driven back towards the operator.

Release switch immediately if blade binds or

saw stalls. Keep blades sharp. Support large

panels as shown in Fig. A. Use fence or

straight edge guide when ripping. Don't force

tool. Stay alert exercise control. Don't remove

saw from work during a cut while the blade is

moving.

NEVER place your hand or fingers behind the

saw. If kickback occurs, the saw could easily

jump backwards over your hand, possibly

causing severe injury.

11. Lower Guard. Raise lower guard with the

retracting handle.

12. Adjustments. Before cutting be sure depth

and bevel adjustments are tight.

13. Use Only Correct Blades In Mounting. Don't

use blades with incorrect size holes. Never

use defective or incorrect blade washers or

bolts.

14. Avoid Cutting Nails. Inspect for and remove all

nails from lumber before cutting.

15. When operating the saw, keep the cord away

from the cutting area and position it so that it

will not be caught on the workpiece during the

cutting operation.

Operate with proper hand support, proper

workpiece support, and supply cord routing

away from the work area.

WARNING:

It is important to support the workpiece prop-

erly and to hold the saw firmly to prevent loss

of control which could cause personal injury.

Fig. D illustrates typical hand support of the

saw.

A typical illustration of proper hand support,

workpiece support, and supply cord routing.

16. Place the wider portion of the saw base on that

part of the workpiece which is solidly sup-

ported, not on the section that will fall off when

the cut is made.

As examples, Fig. E illustrates the RIGHT way

to cut off the end of a board, and Fig. F the

WRONG way. If the workpiece is short or

small, clamp it down. DON'T TRY TO HOLD

SHORT PIECES BY HAND!

Fig. C

Fig. D

Fig. E

Fig. F