CORNING EDGE8 Series Installatie - Pagina 2

Blader online of download pdf Installatie voor {categorie_naam} CORNING EDGE8 Series. CORNING EDGE8 Series 4 pagina's. Single-module housing
Ook voor CORNING EDGE8 Series: Handmatig (11 pagina's)

Pagina afdrukken
3.
Installation
NOTE: Sections 3.2 and 3.3 only apply to EDGE-SMH.
3.1
EDGE™ or EDGE8® MTP® Connector Module into SMH
CAUTION: Scoping Corning CleanAdvantage connectors increases the risk of adding contamination
to the system. CleanAdvantage technology is designed for mating connectors without cleaning or
Remove screws.
1
scoping before the initial installation.
Lift cover o .
TPA-5692
3
Install module
into SMH.
TPA-5693
5
For the initial mating, remove the dust
cap from the LC connectors and mate
the connector into the front of the
module.
TPA-5694
For initial mating, remove the dust
2
cap from the MTP® connector and
dustcap by pulling on the dust cap
while holding the connector
body/housing/shroud.
4
Standard Recommended Procedure 003-892-AEN | Issue 5 | November 2020 | Page 2 of 4
Mate the connector into the rear of
2b
the module.
Replace cover.
Reinsert and
tighten screws.
6
Close hinged lid.