Makita 6922NB Gebruiksaanwijzing - Pagina 5
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 6922NB. Makita 6922NB 8 pagina's. Shear wrench
Ook voor Makita 6922NB: Opsplitsing onderdelen (3 pagina's), Gebruiksaanwijzing (12 pagina's), Opsplitsing onderdelen (3 pagina's)
Pagina afdrukken
004988
OPERATION
Bolt installation
Slip the tool onto the bolt so that the inner sleeve
completely covers the bolt tip.
004989
CAUTION:
Be careful when fitting the sleeve onto the bolt tip.
•
Striking the tip can damage it so that it will no longer
fit inside the sleeve properly.
First tighten bolts preliminarily by using a hand
•
wrench and then tighten them with this tool. Use
this tool only after preliminary tightening without
starting the tightening with this tool.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the nut.
If the tool fails to fit completely over the nut, twist the tool
slightly right and left while pushing forward.
1. There should be
1
no gap between
the outer sleeve
and the tool.
2. Outer sleeve
3. Screw
2
3
1. Inner sleeve
1
2. Bolt tip
2
004990
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
004991
Release the switch trigger and withdraw the tool in a
straight line.
004992
CAUTION:
Do not force the tool down excessively. Apply the
•
downward force to the degree just needed to hold
the tool firm.
Pull the tip ejector (tip lever) to eject the bolt tip from the
tool. Catch the sheared bolt tips to prevent them from
falling dangerously below. Keep the tips off of the ground,
floor, walkways, etc. to prevent injury from tripping or
falling.
5
1. Outer sleeve
1
2. Nut
2
1. Notched portion
1
2. Bolt tip
2
1. Outer sleeve
1