Garantia GRAF GARDEN 500 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garantia GRAF GARDEN 500. Garantia GRAF GARDEN 500 16 pagina's.

Pagina afdrukken

d) Before start-up, fill the pump body and suction hose with clear water. Fill very slowly until the water

overflows; wait a few seconds for all the air to leave and then top up until the level remains

unchanged.

e) Make sure that the voltage matches that indicated on the rating plate and plug in the appliance. Start

the pump and wait for the water to start coming out. If nothing happens after 2-3 minutes, switch off

the plug and fill it again.

5. Technical data

Model

Voltage/frequency

Power

Max. flow rate

Maximum head

Guaranteed sound pressure

6. Troubleshooting

Before troubleshooting, disconnect the pump from the power supply (i.e. remove the

plug from the socket).

If the power cord or a pump components is damaged, all repairs or replacements must be

made by the manufacturer, its technical assistance service or an equivalently qualified

person, in order to prevent all risks.

Fault

The pump does

1) No mains voltage.

not run

2) Shaft blocked.

The pump runs

1) There is still some air remaining in

but does not

the pump body. No water in the

deliver water.

pump body.

2) Air enters from the suction hose.

Thermal

1) The voltage does not correspond

overload

to that shown on rating plate (too

protector

high or too low).

switches off the

2) A solid has blocked the impeller.

pump.

3) The water in the pump is too hot.

4) The pump ran dry for more than

10 minutes.

GARDEN 500

230V/50Hz

600 W

40 l/1'

36 m

76 L

dB (A)

Reason

1) Make sure that voltage reaches the socket and

that the plug is correctly fitted.

2) Remove the plug from the socket, fit a

screwdriver into the notch on the shaft (from

the cooling fan side) and turn to release.

1) Stop the pump, unscrew the delivery hose,

shake the pump and suction hose to help

eliminate the air bubbles; top up with water,

connect and tighten the suction hose and start

the pump again.

2) Make sure that suction hose and fittings are

firmly fixed.

Makes sure there are no counter-slopes,

siphons, goosenecks or smaller diameters in

the suction hose and that the foot valve on the

is not blocked.

Unplug the pump, eliminate the reason for

overheating, wait for the pump to cool and then

switch back on.

GARDEN 700

230V/50Hz

700 W

50 l/1'

40 m

76 L

dB (A)

Remedy