KitchenAid 36" Handleiding voor installatie-instructies - Pagina 8

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid 36". KitchenAid 36" 16 pagina's. 30” and 36” gas sealed burner glass cooktops
Ook voor KitchenAid 36": Installatie-instructies (5 pagina's)

Pagina afdrukken

Unpack Range

WARNING

Excessive Weight Hazard

Use two or more people to move and install range.

Failure to do so can result in back or other injury.

1. Remove shipping materials, tape and protective film from

range. Keep shipping pallet under range. Remove oven racks,

grates and parts package from inside oven.

2. Remove the 2 screws on each side of the top of the bottom

vent. Slide the vent down and pull toward you. Lay this part to

the side to avoid scratching the stainless steel.

A. Bottom vent

B. Remove these screws.

3. Lay a piece of cardboard from side packing on the floor

behind range. Using 2 or more people, firmly grasp each side

of range. Lift range up about 3" (8 cm) and move it back until

range is off shipping pallet. Set range on cardboard to avoid

damaging floor.

Level Range

1. Move range close to the cabinet opening.

2. Place a rack in oven.

3. Place level on rack, first side to side, then front to back.

4. If the range is not level, adjust the feet up or down. Turn

leveling leg sleeves to level range and to raise or lower range

to the desired countertop height.

A. Leveling leg sleeve

NOTE: Range must be level for satisfactory baking performance.

INSTALLATION INSTRUCTIONS

Install Anti-Tip Bracket

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to wall behind range.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death

or serious burns to children and adults.

1. Choose the correct anti-tip bracket for your installation.

If the wall behind the range has no baseboard or has a

baseboard up to

" (0.95 cm) thick, use the shorter

1" (2.5 cm) anti-tip bracket.

If the wall behind the range has a baseboard thicker than

" (0.95 cm), use the longer 1¾" (4.4 cm) anti-tip bracket.

2. Locate a stud on the wall behind the range. Measure the

distance from top of rear brace to floor.

A. Rear brace

B. Top of rear brace to floor

C. Top of rear brace

D. Floor

3. Add

" (0.79 cm) to the measurement from Step 2. This will

allow anti-tip bracket to slide over rear brace.