James Loudspeakers M1000 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} James Loudspeakers M1000. James Loudspeakers M1000 20 pagina's. 1000w (4/8 ohm and 70v) dsp subwoofer amplifier
Pagina afdrukken
FRONT PANEL
1
Power Indicator - The word power will appear in blue when the unit is powered on and is out of standby
mode.
2
Standby Indicator - The word Standby will appear in red when the M1000 is in standby mode. The
M1000 is put into Standby Mode by turning the amplifier off through either the remote, the auto off mode or the
12V trigger. Also, if the amplifier overheats, the standby indicator will come on as the amplifier will go into
standby mode.
3
Clipping Indicator - The word Clip will flash in red when the power output exceeds the 1000W power
rating of the amplifier. Although running the M1000 into clipping is not recommend for sonic and woofer
reliability reasons, occasional clipping is generally acceptable on music and movie sources due to their very
dynamic nature. However, if any distortion is heard the amplifier level should be reduced.
4
Signal Indicator - The word Signal will flash in green when a signal is present on the inputs.
5
IR sensor/receiver - IR signals from the remote control are received here. If a IR sensor is plugged into the
rear IR input jack, this sensor will be turned off.
6
16 character x 2 row Liquid Crystal Display - Shows the amplifier s status, menus and settings and works
in conjunction with the 5 button navigation controls and the remote control.
7
5 button programming navigation controls - Used to scroll through the Display menus, change settings
and program the DSP controller.
8
USB Connector - For uploading new firmware/software.
9
Optional rack ears - Two rack mount ears for 19-inch rack mounting are provided for rack mounting. The
rear mounting holes should also be used for supporting the amplifier in a rack cabinet.
3
4
5
1
2
6
7
8
9
Page 6