KitchenAid Architect Series II KGRS807S Afmetingen

Blader online of download pdf Afmetingen voor {categorie_naam} KitchenAid Architect Series II KGRS807S. KitchenAid Architect Series II KGRS807S 1 pagina's. 30" freestanding and slide-in gas range
Ook voor KitchenAid Architect Series II KGRS807S: Afmetingen (1 pagina's)

Pagina afdrukken

PRODUCT MODEL NUMBERS

KGRS807S

KGSS907S

KGSK901S

Gas supply: Use 3/4" (1.9 cm) rigid pipe gas

supply line to the range location. A smaller size

pipe on long runs may result in insufficient gas

supply. With L.P. gas, piping or tubing size can

be 1/2" (1.3 cm) minimum. If local codes

permit, it is recommended that new flexible

metal tubing, design-certified by CSA, 4-5 feet

(122-152.4 cm) long, 1/2" (1.3 cm) or 3/4"

(1.9 cm) I.D., be used for connecting the range

to the rigid gas supply line. A 1/2" (1.3 cm)

male pipe thread is needed for connection to

pressure regulator female pipe threads. An

easily accessible individual manual shutoff

valve must be located in the same room, but

external to the range.

Electrical: 120-volt, 60 Hz, AC-only, 15 amp,

fused electrical circuit is required. A separate

circuit is recommended. A time-delay fuse or

circuit breaker is recommended.

SLIDE-IN RANGE COUNTERTOP PREPARATION

The cooktop sides of the slide-in range fit over

the cutout edge of your countertop.

If you have a square finish (flat) countertop

and the opening width is 30" (76.2 cm), no

countertop preparation is required.

Formed front-edged countertops must have

molded edge shaved flat 3/8" (1.0 cm) from

each front corner of opening.

Tile countertops may need trim cut back

CABINET OPENING DIMENSIONS

13" (33 cm) upper

cabinet depth

30" (76.2 cm) min.

opening width

18" (45.7 cm)

30" (76.2 cm)

upper cabinet

min. opening

to countertop

width

Grounded

outlet

5" (12.7 cm) min.

(20.3 cm)

clearance from

both sides of the

(20.3 cm)

range to the side

wall or other

7" (17.8 cm)

combustible

material.

Available area

for gas and electric

installation.

4¹⁄

(11.4 cm)

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

30" Freestanding and Slide-In Gas Range

OVERALL DIMENSIONS

" (14.6 cm)

B. 30" (76.2 cm)

C. 41 " (106 cm) overall height

with leveling legs screwed all

the way in.

D. 36" (91.4 cm) cooktop trim

height with leveling legs

screwed all the way in*

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1" (2.5 cm) beyond

24" (61 cm) base cabinet.

3/8" (1.0 cm) from each front corner and/or

rounded edge flattened.

If countertop opening width is greater than

30" (76.2 cm), adjust the 3/8" (1.0 cm)

dimension.

Countertop must be level. Place level on

countertop, first side to side; then front to

back. If countertop is not level, range will not

be level. Range must be level for satisfactory

baking conditions.

For minimum

clearance to top

of the cooktop,

see NOTE.

Cabinet door

This shaded area

or hinge

recommended for

should not

installation of

extend into

outlet or

the cutout.

junction box.

4¹⁄

(11.4 cm)

1¹⁄

" (3.8 cm)

This shaded area

recommended for

installation of

rigid gas pipe.

Freestanding Range

F**

E. Model/serial number plate

(located on the right-hand

side oven door trim)

F. 27 " (69.2 cm) max. from

handle to standoff at back

of range**

13" (33 cm) max.

upper cabinet depth

30" (76.2 cm) min.

opening width

18" (45.7 cm)

¾" (1.9 cm)

upper cabinet

radius both corners

to countertop

5" (12.7 cm) min.

(20.3 cm)

clearance from

both sides of the

range to the side

(20.3 cm)

wall or other

combustible

7" (17.8 cm)

material.

This shaded area

recommended for

1¹⁄

installation of

(3.8 cm)

rigid gas pipe.

4¹⁄

(11.4 cm)

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Slide-in Range

E**

A. 30

" (77.6 cm)

B. 35 " (90.5 cm) height to

underside of cooktop edge

with leveling legs screwed

all the way in*

C. Model/serial number plate

(located on the right-hand

side oven door trim)

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1 " (4.4 cm) beyond

24" (61 cm) base cabinet.

30"

(76.2 cm)

30 ³⁄₄"

(78.1 cm)

For minimum

clearance to top

of the cooktop,

see NOTE.

" (58.3 cm)

opening depth

30" (76.2 cm)

min. opening

width

Grounded

outlet

Cabinet door

This shaded area

or hinge

recommended for

should not

installation of

extend into

outlet or

the cutout.

junction box.

4¹⁄

(11.4 cm)

Available area

for gas and

electric

installation.

D 30" (76.2 cm)

E. 27¼" (69.2 cm) from

handle to standoff at

back of range**

F. 23" (58.4 cm) countertop

notch to rear of cooktop

³⁄₈"

(1.0 cm)

NOTE: 24" (61 cm) minimum

when bottom of wood or

metal cabinet is protected by

not less than 1/4" (0.64 cm)

flame retardant millboard

covered with not less than

No. 28 MSG sheet steel,

0.015" (0.4 mm) stainless

steel, 0.024" (0.6 mm)

aluminum or

0.020" (0.5 mm) copper.

30" (76.2 cm) minimum

clearance between the top of

the cooking platform and the

bottom of an unprotected

wood or metal cabinet.

If installing a range hood or

microwave hood combination

above the range, follow the

range hood or microwave

hood combination

installation instructions for

dimensional clearances

above the cooktop surface.

Ref. W10118262

04-18-07