Makita BHS630 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita BHS630. Makita BHS630 13 pagina's.
Ook voor Makita BHS630: Technische informatie (16 pagina's)

Pagina afdrukken

Overloaded:

•

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, release the trigger switch on

the tool and stop the application that caused

the tool to become overloaded. Then pull the

trigger switch again to restart.

If the tool does not start, the battery is

overheated. In this situation, let the battery

cool before pulling the trigger switch again.

Low battery voltage:

•

The remaining battery capacity is too low and

the tool will not operate. In this situation,

remove and recharge the battery.

Adjusting depth of cut

012098

CAUTION:

After adjusting the depth of cut, always tighten the

•

lever securely.

Loosen the lever on the side of the rear handle and

move the base up or down. At the desired depth of cut,

secure the base by tightening the lever.

For cleaner, safer cuts, set cut depth so that no more

than one blade tooth projects below workpiece. Using

proper cut depth helps to reduce potential for dangerous

kickback which can cause personal injury.

Bevel cutting

012100

Loosen the wing screw on the front and rear base. Set

for the desired angle (0° - 45°) by tilting accordingly, then

tighten the wing screw securely.

1. Lever

1. Wing screw

Sighting

012107

For straight cuts, align the 0° position on the front of the

base with your cutting line. For 45° bevel cuts, align the

45° position with it. The position of the top guide is

adjustable.

Switch action

012105

CAUTION:

Before installing the battery cartridge into the tool,

•

always check to see that the switch trigger

actuates properly and returns to the "OFF" position

when released.

Do not pull the switch trigger hard without pressing

•

the lock-off lever. This can cause switch breakage.

To prevent the switch trigger from being accidentally

pulled, a lock-off lever is provided. To start the tool,

press the lock-off lever and pull the switch trigger.

Release the switch trigger to stop.

WARNING:

For your safety, this tool is equipped with lock-off

•

lever which prevents the tool from unintended

starting. NEVER use the tool if it runs when you

simply pull the switch trigger without pressing the

lock-off lever. Return tool a MAKITA service center

for proper repairs BEFORE further usage.

1. Cutting line

2. 45 ﾟ position

3. 0 ﾟ position

4. Screw

5. Top guide

1. Switch trigger

2. Lock-off lever