Makita BTM40 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita BTM40. Makita BTM40 12 pagina's. Cordless multi tool
Ook voor Makita BTM40: Technische informatie (10 pagina's)

Pagina afdrukken

Adjusting the orbital stroke rate

012770

The orbital stroke rate is adjustable. To change the orbital

stroke rate, turn the dial between 1 and 6. The higher the

number is, the higher the orbital stroke rate is. Preset the

dial to the number suitable for your workpiece.

NOTE:

The dial cannot be turned directly from 1 to 6 or

•

from 6 to 1. Forcing the dial may damage the tool.

When changing the dial direction, always turn the

dial moving it through each intermediate number.

Lighting up the front lamp

WARNING:

Never look into the light directly. Direct light causes

•

damage to your eyes.

012779

Slide the slide switch toward the "I (ON)" position to light

up the front lamp. The lamp keeps on lighting while the

switch is the "I (ON)" position. The light automatically

goes out after pressing the rear of the slide switch, and

then sliding the slide switch toward the "O (OFF)"

position.

Overload protection

When the tool is overloaded and the tool temperature

reaches a certain level, the front lamp blinks and the tool

automatically stops. Remove a cause of overload to

restart.

1. Dial

1. Front lamp

Indication lamp

012771

When the remaining battery capacity gets low, the

•

indication lamp blinks.

When the remaining battery capacity gets much

•

lower, the tool stops during operation and the

indication lamp lights up about 10 seconds.

At this time, remove the battery cartridge from the tool

and charge it.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before carrying out

any work on the tool.

Installing or removing application tool

(optional accessory)

WARNING:

Do not install application tool upside down.

•

Installing application tool upside down may damage

the tool and cause serious personal injury.

Install attachment tool in the correct direction

•

according to your work. Application tool can be

installed at an angle of every 30 degree.

012826

1. Indication lamp

1. Application tool

installation bolt

2. Holes in the

application tool

3. Protrusions of

the tool flange