Frisco 250608 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Frisco 250608. Frisco 250608 2 pagina's. 3-panel gate

Pagina afdrukken

GET SET

Prior to assembly, please be sure to identify all parts shown below.

A. Gate Frame (1)

THE TOOLS FOR THE JOB

Aside from the included parts, you'll also need:

C. A Phillips head screwdriver*

D. A buddy (optional)

*No power tools allowed!

FIRST GOES THE GATE

INSTALLING THE GATE

Loosen

STEP 1

Bring the gate to the installation area. Loosen the lock

nuts on both sides of the door panel to allow the gate to unfold

freely. Do not fully remove the lock nuts. Unfold the gate and set

it up in the installation area. Pat yourself on the back!

For questions, please call 1-800-672-4399.

B. Screws (10)

STEP 2

Fix one of the top wall mounting brackets (attached

to the gate) to the wall using a Phillips head screwdriver and two

screws. Repeat for the other top wall mounting bracket, making

sure the gate is even across the opening.

NOTE: The bottom of the gate should be

no more than 1/8 of an inch from the floor.

1/8 inch

STEP 3

Straighten the bottom of the gate to make sure it

isn't leaning, i.e. tipping forward or backward, then repeat the

installation process for both bottom wall mounting brackets.

OPEN DOOR POLICY (OR NOT)

OPERATING THE DOOR, LATCH AND BASE LOCKS

Figure 2

Figure 3

Figure 1

TO OPEN

Make sure the base locks are in the horizontal

position (figure #1). Pull the spring lock away from the easy open

latch (figure #2) and lift the lock lever upwards (figure #3) at the

same time to release it. Then, pull the gate open. Neat, amirite?

For questions, please call 1-800-672-4399.

Tighten

STEP 4

Tighten both lock nuts on either side of the door panel

to lock the gate in place. Time for a treat break!

TO CLOSE

Pull the door shut and make sure the top latch

closes. Move the bottom lock on the side occupied by your pet

(aka their new chill spot) to the down position.

NOTE: If one of the base locks is in the down position, the gate

will only swing open toward the lock. If both are down, the gate

will not open in either direction.

NOTE: The gate will automatically close if left open less than 90°.

Now isn't that handy!