Gardeline EM 700 ELECTRIC Power Handleiding - Pagina 5

Blader online of download pdf Power Handleiding voor {categorie_naam} Gardeline EM 700 ELECTRIC. Gardeline EM 700 ELECTRIC 12 pagina's. Cultivator

Pagina afdrukken

2.3. Electrical safety

• The mains voltage must correspond to the one marked on the tool's
rating label (230V ~50Hz). Do not use other sources of power.
•
For the power supply line, the use of a protective switch (circuit-
breaker) with a nominal breaking current in the range of 10 to 30mA is
recommended. Consult a qualified electrician.
•
Never pass the running tool over the extension cable to which it is
connected, as this could cut the cable. Make sure that you always know
where the cable is.
•
Use the special cable holder (strain relief) for the connection of the
extension cable.
•
Never use the tool when it is raining. Try to prevent it from getting wet
or being exposed to humidity. Do not leave it outside overnight.
3.

Names of parts

1

4. Before starting up

4.1. Intended use

This tool is only intended as an electric tiller for use in domestic and hobby
gardens.
It is not designed for use in public areas, parks, sports facilities, or in
agriculture and forestry. Using the tool for any other purpose is considered
improper and therefore not approved. The manufacturer is not liable for any
damage or injury resulting from such improper or not approved use. The
user is fully liable for any risks associated with such use.

4.2. Double insulation

The electric tiller has double insulation. This means that all external metal
parts are insulated from the electric power supply. This is achieved by
introducing an insulation layer between the electrical and mechanical parts.
The double insulation guarantees you the greatest possible safety.
Helpline No. UK / N.IREL AND 0845 603 9277 Rep. Ireland 1890 8823 74
Web Support www.gardenhomepower.com
Model Number: EM 700 Electric Cultivator
•
The power supply cable should be checked regularly and before each
time it is used; make sure that the cable is not damaged or worn out.
If the cable is not in good condition, do not use the tool; take it to an
authorized service centre instead.
•
Only use extension cables that are suitable for outdoor use. Keep it away
from the cutting area, from damp, wet or oily surfaces or surfaces with
sharp edges and also from heat and fuels.
•
The mobile socket of the extension cable should be splash proof in com-
pliance with the requirements of DIN 57282 and VDE 0282; the cross-
section of the wire (max. length: 75m) should be at least 1.5mm2. Use
H07RN-F harmonized cable.
GB
1.
1.
Safety switch/plug combination
Safety switch/plug combination
2.
Trigger lever
3.
3.
Cable strain relief
Cable strain relief
4.
4.
Guide bar, upper section
Guide bar, upper section
5.
5.
Carrying handle
Carrying handle
6.
6.
Guide bar, lower section
Guide bar, lower section
7.
7.
Motor housing
Motor housing
8.
8.
Protective shield
Protective shield
9.
Fender
10. Tines

4.3. Overheat protection

If the tool is blocked by a foreign object or if the motor is overloaded, the
motor will be automatically switched off by the protection device. Release
the trigger level and wait until the motor has cooled down (approx. 15
minutes), then start the tool again.
5