Avanti WD001 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Avanti WD001. Avanti WD001 12 pagina's. Hot and cold water dispenser
Pagina afdrukken
Before Using Your Water Dispenser
Check to be sure the following parts are included:
Instruction manual
2 extra cup dispenser cabinet plugs (Located in the bag with this manual)
2 extra drain seals (Located in the bag with this manual)
Accessories order form.
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed
with fresh water before use as follows:
Keep the unit unplugged.
Fill water tank with tap water full to capacity. Wait for 15 minutes as indicated above.
Slide child safety button then push the hot water faucet (See the Hot Water Faucet diagram on
the next page) until water comes out, then stop.
Plug the dispenser into the electrical outlet. Locate and flip the COLD (Green) and HOT (Red)
power switches at the rear of the unit to the ON position.
We are ready to complete the first cycle. In order to do that, wait for the hot water to reach
temperature in approximately 10 minutes, and then wait for the cold to reach temperature
(another 40 minutes, approximately).
Warning: The water coming out of the back may be scolding hot
Flip the COLD (Green) and HOT (Red) power switches to the OFF position.
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at
a time until no more water remains. (Note: To facilitate this operation, use a large container).
Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains
completely.
Proceed to close the drain cap tightly and ensure there are no leaks.
Push water faucet buttons to insure water flows from both faucets.
Plug dispenser back into the electrical outlet.
Flip the COLD (Green) and HOT (Red) power switches to the ON position.
Now you are ready to use your water dispenser.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we recommend that you
turn off the hot water function.
OPERATION INSTRUCTIONS:
7