Corsa 14255 Handleiding voor installatie-instructies - Pagina 5
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Corsa 14255. Corsa 14255 6 pagina's. Twin pro series 4" exhaust system for chevrolet ssr 2004; chevrolet ssr 2005; chevrolet ssr 2006
Pagina afdrukken13) Place the grommet shown in Fig. Z onto the hanger of the driver side
pipe assembly. Then tighten down the 2.5" Torca clamp at the Driver
Side Tail Pipe to Y-Pipe connection. Do not tighten the clamp
completely until the rest of the system is in place. Spray some soapy
water in grommet to help.
14) At this point, your pipes should look similar to the SSR rear view
shown in Fig. AA.
15) Begin to install the CORSA 4" Pro-Series tips on both the driver and
passenger side tail pipes. Continue to Step 16 on next page.
16. Place the 4" Pro-Series tips onto both tailpipes. The tips should be
recessed approximately 3/8" inside the tip pocket. The tabs on the
clamps must be facing toward the center of the vehicle. At this time
the clamps can be fully tightened. (See FIG. BB)
17. Install the tie bar with the side that has the hole thru the tab between
the tabs on the passenger side clamp. Use the bolt and nut provided
in the hardware kit to hold the tie-bar in place. (See FIG. CC)
18. Slide the Tie-Bar between the tabs on the driver side clamp.
NOTE: The tab attached to the Tie-Bar on the Driver Side is slotted.
This is to give the installer adjustment when finalizing the tip alignment.
(See FIG. DD)
19. Align the Driver side tip so that it is concentric with the opening in
the bumper then tighten the nut and bolt through the clamp tabs and
tie bar. (See FIG. EE)
20. See FIG. FF for a view of the Tie-Bar fully assembled to the driver
and passenger side clamps.
21. The tips should be evenly spaced with the completion of the Tie-Bar
assembly as shown in FIG. GG.
Now you may completely tighten ALL Torca clamps on the exhaust
system to the
Torca torque specification of 45 ft.-lbs.
Finally, finish tightening the nuts at the flange connection shown on
page 3 in Fig. N. When tightening flange bolts, alternately tighten
each bolt so the spacing is even all the way around the flange
connection. Uneven tightening may result in an exhaust leak.
Torque the flange nuts to 60 ft.-lbs.
FIG. DD
FIG. EE
FIG. FF
FIG. Z
FIG. AA
FIG. BB
FIG. CC
FIG. GG