GARDEN MASTER GM1818 Montagehandleiding - Pagina 2

Blader online of download pdf Montagehandleiding voor {categorie_naam} GARDEN MASTER GM1818. GARDEN MASTER GM1818 8 pagina's. Sloping roof shed
Ook voor GARDEN MASTER GM1818: Montage-instructies (2 pagina's), Montagehandleiding (8 pagina's)

Pagina afdrukken
GARDEN MASTER GM1818 Montagehandleiding

ASSEMBLY OVERVIEW

These instructions are designed to guide you though the process
of building your new garden shed. It is a simple process of joining
sheets together before adding top and bottom channels to form a
shed panel. These panels are then joined together to make your shed.
When fitting the channels to the sheets, the high side of the channel should go on the inside of the sheet, ensuring that
any water that collects in the bottom channel will run over the lower side and run away rather than into the shed.
Rivets are fitted by drilling through outside of the channel into the ribs of the sheet, usually at every second rib. It is
also important to fit at least one rivet per sheet from the inside of
the channel into the pan of the sheet, close to a rib. Extra rivets
should be fitted on the inside of the channel into the pan of the
sheets in high wind areas.
It is critical that you remove the swarf (the metal filings created
when drilling) from the panels and channels as you assemble
them as these will rust quickly and could cause corrosion issues
with your shed!

COMPONENTS CHECKLIST

Please check the parts carefully and advise immediately if any are damaged or missing.
2
x 1830mm sheets for the back
1 / 2
A
1 x 290mm wide sheet with door
D
jamb attached
4 x 1815mm channels with ends cut for
G
front and back walls
1 x pack of rivets, 1 x riveter, 1 x drill bit. and a padbolt pack with wide
J
flanged rivets for fixing the padbolt on to the door and door jamb.
If you need advice, call us
2
If you choose to vary from these instructions your warranty will be impaired.
4 x sloping sheets and 2 x
B
for end walls (2
Door pre-hinged to 740mm sheet with
E
door jamb
2 x 1980mm 'L's for flashing the roof to
H
the side walls
FREE
on
0800 807 433
or email us at [email protected]
INSIDE
OUTSIDE
sheets
1 / 2
C
left, 2
right)
1 / 2
1 / 2
F
K
PAN
2
x 1980mm sheets for the roof
1 / 2
6 x 1815mm channels for end walls
and the roof
2 x 793mm door spacers
I
2 x 'Z' door braces
RIB