KitchenAid YKESA907PP00 Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid YKESA907PP00. KitchenAid YKESA907PP00 20 pagina's. 30"(76.2cm) freestanding and slide-in electric ranges

Pagina afdrukken
Besure that t heelectrical connection andwire size areadequate
andinconformance
withCSA Standard C22.1, Canadian
Electrical Code, Part 1 - latest edition, and alllocal c odes a nd
ordinances.
Acopyoftheabove c ode standards canbeobtained from:
Canadian Standards Association, 178 Rexdale Blvd., Toronto,
ONM9W 1R3 CANADA.
• Donotground t oagaspipe.
• Check w itha qualified electrical installer ifyouare notsure
therange isproperly grounded.
• Donothave afuse intheneutral orground c ircuit.
When a4-wire, single phase 1 20/240-volt,
60Hz, AC-only
electrical supply isavailable, a50amp maximum c ircuit
protection isrequired (or, i fspecified onthemodel/serial
rating plate, w hen a4-wire, single phase 1 20/208-volt 60Hz,
AC-only electrical supply isavailable, a40amp maximum
circuit p rotection isrequired), fused onbothsides o ftheline.
• Atime-delay fuse orcircuit b reaker isrecommended.
This range i sequipped withaCSA International
Certified
Power Cord intended tobeplugged i ntoastandard 1 4-50R
wall r eceptacle. Besure thewall r eceptacle iswithin reach of
range's final l ocation.
The cooktop s ides oftheslide-in r ange f itover t hecutout edge of
your c ountertop.
_r_.... ........
(57.8 cm_
If you have a square finish (flat) countertop and the opening width
is 30" (76.2 cm), no countertop
preparation is required.
Formed front-edged
countertops
must have molded edge
shaved flat %" (1.0 cm) from each front corner of opening.
Tile countertops
may need trim cut back 3/8"(1.0 cm) from each
front corner and/or rounded edge flattened.
\
•
Do not use an extension cord.
If countertop
opening width is greater than 30" (76.2 cm), adjust
the %" (1.0 cm) dimension.
Countertop
must be level. Place level on countertop,
first side to
side; then front to back. If countertop
is not level, range will not
be level. Oven must be level for satisfactory
baking performance.
INSTALLATION INSTRUCTIONS
2,
Remove shipping materials, tape and protective film from
range. Keep cardboard bottom under range. Remove oven
racks and parts package from inside oven.
Take 4 cardboard corners from the carton. Stack one
cardboard corner on top of another. Repeat with the other
2 corners. Place them lengthwise on the floor behind the
range to support the range when it is laid on its back. Firmly
grasp the range and gently lay it on its back on the cardboard
corners.
3. Pull cardboard bottom firmly to remove.
4. Use an adjustable wrench to loosen the leveling legs.
5. Place cardboard or hardboard in front of range. Stand range
back up onto cardboard or hardboard.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti4ip
bracket to rear range foot.
Reconnect
the antFtip bracket,
if the range is moved.
Failure to follow these instructions
can result in death
or serious burns to children
and adults.
Contact a qualified floor covering installer for the best procedure
for drilling mounting holes through your type of floor covering.
Before moving range, slide range onto shipping base, cardboard
or hardboard.
1. Remove template from the anti-tip bracket kit (found inside
the oven cavity).