Jancy Engineering Slugger MCCS14-2 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Jancy Engineering Slugger MCCS14-2. Jancy Engineering Slugger MCCS14-2 16 pagina's. 14" metal cutter
Pagina afdrukken
Remove all contents from packaging and inspect to ensure no damage was incurred during shipping. Your Slugger
14" Metal Cutter package should also include the following:
WARNING: To avoid injury from unexpected starting or electrical shock, do not plug the power cord into
a power source outlet during unpacking and assembly. This cord must remain unplugged whenever you are
working on the saw.
1. Remove the saw from the carton by lifting the saw with the carrying handle.
2. Place the saw on a secure, stationary work surface and look the saw over carefully.
WHAT YOU SHOULD KNOW BEFORE SAWING
1. Type of material to be cut (which determines blade selection), thickness and position should all be determined to
ensure proper performance.
2. Remove any excessive mill scale or rust from surface to be cut.
3. Material that has been flame cut may have become heat treated and therefore difficult to cut. Avoid sawing near
such areas whenever possible.
do not operate machine if warning and/or instruction labels are missing or damaged.
1. If you require an additional manual, please contact Jancy
Engineering at (563) 391-1300 for a FREE copy.
2. Only use specified and approved saw blades.
3. Keep saw blades securely fastened.
4. Do not use dull or broken blades.
5. Beware of chips ejected. They become HOT during the cut.
6. Always make safe provisions for handling of excess material.
7. Keep bottom of base plate free from dirt and other debris.
contents of package
description
OPERATOR'S MANUAL
PRODUCT DVD
WARRANTY CARD
2.5MM HEX WRENCH
6MM HEX WRENCH
8MM HEX WRENCH
EAR PLUGS
SAFETY GOGGLES
SAW BLADE
specific safety rules and symbols
contact Jancy engineering for replacement labels.
EYE
HEARING
PROTECTION
PROTECTION
REQUIRED
REQUIRED
#
part
LIT122
LIT032
0070342
UH8000
UH8015
UH8016
MC702301
MC702302
MCBL14
WARNING!
NEVER PLACE
LINE
FINGERS NEAR
VOLTAGE
CUTTING AREA
PRESENT
V .............................................volts
A ............................................amperes
Hz ...........................................hertz
min ..........................................minutes
s .............................................seconds
~............................................alternating current
no ...........................................no load speed
qty
1
1
1
1
1
1
1
1
1
BEWARE OF
ROTATING
MACHINE
PARTS
®
6