Garden Sun HPS-C-SH Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Garden Sun HPS-C-SH. Garden Sun HPS-C-SH 11 pagina's. Tabletop

Pagina afdrukken

1. Turning on the Heater

Step 4 – The Guard Assembly

Put the Guard on the Burner through the Emitter screen.

Put the ends of the Guard into the holes of the Burner.

Step 5 – The Reflector Assembly

Put 3pcs washers on each

pins of the 60mm length.

Fasten the reflector with 3pcs castle nuts.

Step 6 – Gas Tank Assembly

You must provide propane gas and propane cylinder .

Use a standard 1.02 lb. propane cylinder only.

Storage of an appliance indoors is permissible only if the

cylinder is disconnected and removed from the appliance.

A cylinder must be stored outdoors in a well-ventilated area

out of the reach of children. A disconnected cylinder must

have dust caps tightly installed and must not be stored in a

building, garage or any other enclosed area.

Standard 1.02 lb. tank

The pressure regulator supplied with the appliance must

be used.

The installation must conform with local codes, or in the

absence of local codes,with National Fuel Gas Code,

ANSI Z223.1/NFPA54, Natural Gas and Propane Installation

Code, CSA B149.1, or Propane Storage and Handling

Code, B149.2.

Only a cylinder marked "propane" can be used.

Certain materials or items, when stored under the heater,

will be subjected to radiant heat and could be seriously

damaged.

Put the reflector through

the pins and on the washers.

A dented, rusted or damaged propane cylinder may be hazardous

and should be checked by your cylinder supplier. Never use a

propane cylinder with a damaged valve connection.

The propane cylinder must be constructed and marked in

accordance with the specifications for LP gas cylinders of the

U.S. Department of Transportation (DOT). or the Standard for

Cylinders, Spheres and Tubes for Transportation of Dangerous

Goods and Commission, CAN/CSA-B339.

Provided with a listed overfilling prevention device.

Provided with a cylinder connection device compatible with the

connection for the appliance.

The cylinder used must include a collar to protect the cylinder valve.

Never connect an unregulated propane cylinder to the heater.

Turn off the control knob of the burner.Fix the 1.02 lb.

propane cylinder to the regulator(rotate the propane cylinder

clockwise on the regulator untill tightened).

Close the door plate and lock it with the handle.

The cylinder must be disconnected when the appliance is not used.

Storage of an appliance indoors is permissible only if the cylinder

is disconnected and removed from the appliance.

An appliance may be installed with shelter no more inclusive than:

(a) With walls on all sides,but with no overhead cover.

(b) Within a partial enclosure which includes an overhead cover

and no more than two side walls. These side walls may be

parallet, as in a breezeway, or at right angles to each other.

and three side walls, as long as 30 percent or more of the

horizontal periphery of the enclosure is permanently open.

(a) Do not store a spare LP-gas cylinder under or near this appliance;

(b) Never fill the cylinder beyond 80 percent full;

cylinder is not in use. Only install the type of dust cape on the

cylinder valve that provided with the cylinder valve. Other type of

caps or plugs may result in leakage of propane."

Replacement pressure regulator must be that specified by the

appliance manufacturer.