ALICE NightOne Snelstarthandleiding - Pagina 5
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} ALICE NightOne. ALICE NightOne 6 pagina's.
Pagina afdrukken
Pulse oximeter
1.
Figure 8. Put the pulse oximeter on your finger
Put the rubber sensor on one of your index (pointer) fingers (see Figure 8).
The pulse oximeter only works on a natural, clean nail. If you have a fake
o
nail or are wearing nail polish, remove this before putting the pulse
oximeter on.
o
Place the sensor so the wire goes over the back of your hand.
2. Take several breaths with the pulse oximeter in place. The pulse oximeter icon
should turn green. If it doesn't, check the position of the sensor. Make sure it's
securely in place. Then, take a few more breaths and check the icon again.
How to Start Your HST
Once all the sensors are connected and working properly, the 3 sensor icons and the
good study indicator will be solid green. After about a minute, the icons will start to turn
off one by one. Once all the icons have turned off, the Alice NightOne device is ready.
You may now go to sleep.
You can sleep in your usual position (such as on your back, side, or stomach) during
your HST. Leave the Alice NightOne device and sensors on all night, even if you get up
to use the restroom or for any other reason. If any of the sensors slip off or move during
the night, put them back on. You don't need to stop your HST.
How to End Your HST
To end your HST, take off the sensors and disconnect them from the Alice NightOne
device. The device will turn off automatically.
Put the Alice NightOne device and sensors back into the carrying case. Bring the case,
device, and sensors back to the Memorial Sleep Lab where you picked it up.