Makita HM1801 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita HM1801. Makita HM1801 12 pagina's. Electric breaker
Ook voor Makita HM1801: Gebruiksaanwijzing (10 pagina's), Gebruiksaanwijzing (8 pagina's), Gebruiksaanwijzing (20 pagina's), Gebruiksaanwijzing (12 pagina's), Gebruiksaanwijzing (8 pagina's), Technische informatie (18 pagina's)
![Makita HM1801 Gebruiksaanwijzing](/uploads/products/server2/2126730/2126730.png)
1
2
3
4
1. Bit
2. Tool retainer
3. Tool holder
4. When the bit is inserted
5. When the bit is retained
1
2
4
3
1. Notched portion
2. Tool retainer shaft
3. Barrel
4. When the bit is inserted
5. When the bit is retained
OPERATION
MAINTENANCE
1
1. Commutator
2. Insulating tip
3. Carbon brush
(1) For bits with a collar
006202
Pivot the tool retainer back and slightly downward. Insert the bit into the
Fig.1
tool holder as far as it will go. To securely retain the bit, return the tool
retainer to its original position.
CAUTION:
•
Always assure that the bit is securely retained by attempting to pull the
bit out of the tool holder after completing the above procedure.
5
(2) For bits without a collar
006201
Pivot the tool retainer front and slightly downward. With the notched por-
Fig.2
tion of the bit facing the tool retainer shaft, insert the bit into the tool
holder as far as it will go. Then pivot the tool retainer further downward
toward the barrel to securely retain the bit.
CAUTION:
•
Always assure that the bit is securely retained by attempting to pull the
bit out of the tool holder after completing the above procedure.
5
•
The bit without a collar cannot be retained by the method shown in
Fig.(1).
To remove the bit, follow the installation procedure in reverse.
Chipping/Scaling/Demolition
Hold the tool firmly with both hands. Turn the tool on and apply slight pressure
on the tool so that the tool will not bounce around, uncontrolled. Pressing very
hard on the tool will not increase the efficiency.
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001146
When the resin insulating tip inside the carbon brush is exposed to contact the
commutator, it will automatically shut off the motor. When this occurs, both car-
2
bon brushes should be replaced. Keep the carbon brushes clean and free to
slip in the holders. Both carbon brushes should be replaced at the same time.
Use only identical carbon brushes.
3
7