KitchenAid KEBS209BSS Installatie- en bedieningshandleiding - Pagina 5
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} KitchenAid KEBS209BSS. KitchenAid KEBS209BSS 10 pagina's. Built-in oven
Pagina afdrukken
Prepare Built-In Oven
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. If installing a single oven below a cooktop, remove the
adhesive backing from the foam strip and press it to the back
of the control panel.
NOTE: When the cooktop is installed in the cabinet, the top
edge of the foam strip should be approximately ³⁄₈" (10 mm)
from the top edge of the control panel. Make sure the foam
strip is positioned against the cabinet face.
A
A. Foam strip
7. Move oven and cardboard close to the oven's final location.
Remove Oven Door
IMPORTANT: Use both hands to remove oven door(s).
1. Open the oven door.
2. Locate the oven door latches in both corners of the oven
door, and rotate the latches forward to the unlocked position.
A. Oven door latch in locked
position
6
INSTALLATION INSTRUCTIONS
A
B. Oven door latch in unlocked
position
3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove. Set the oven door(s) aside on a
covered work surface.
Positioning Oven Feet for Multiple Cabinet
Single Ovens
The positioning of the oven feet allow a single oven to be
installed in a cutout height between 26¹⁵⁄₁₆" (68.4 cm) and 29⁷⁄₁₆"
(74.8 cm). Refer to the following instructions to position the feet
for the size of your cabinet cutout.
Cutout height is between 27⁵⁄₈" (70.2 cm) and
28⁵⁄₈" (72.7 cm)
The oven feet do not need to be changed. They are positioned
correctly as received.
Go to the "Make Electrical Connection" section.
B
Cutout Heights