Jandy Jandy Pro Series Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} Jandy Jandy Pro Series. Jandy Jandy Pro Series 8 pagina's. Single element cartridge pool & spa cs filters
Ook voor Jandy Jandy Pro Series: Gebruikershandleiding (12 pagina's), Installatiehandleiding (16 pagina's), Installatie- en bedieningshandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Snelstarthandleiding (2 pagina's), Installatie- en bedieningshandleiding (20 pagina's), Installatie-instructies (2 pagina's), Installatie- en bedieningshandleiding (16 pagina's), Installatie- en bedieningshandleiding (16 pagina's), Installatie- en bedieningshandleiding (16 pagina's)

Pagina afdrukken

Page 6

Comm Hole

Figure 9.

Accessing and Wiring to the Power PCB

7. In the AquaLink RS or PDA power center, wire the

power pack directly to the LOAD SIDE of the filter

pump relay (see Figure 10 and 12).

8. The AquaLink RS or PDA and power pack use a

four (4) wire connection to communicate and can be

wired up to 500 feet apart. Any outdoor rated four

conductor cable, minimum 22 AWG, can be used.

Locate the appropriate screw terminals on the circuit

board and wire the power pack to the AquaLink RS

or PDA red 4-pin terminal bar

(see Figure 11).

NOTE The screw terminals on the AquaLink RS or

PDA are removable to aid in installation.

Jandy

Pro Series AquaPure

Ei™ Series

AquaLink RS or PDA Power Center

To Filter Pump

(240 VAC)

Cable Tie

To Filter Pump

(120 VAC)

Figure 10.

Red, 4-Pin

Terminal Bar

Figure 11.

Replacement Kit Instructions

240 VAC

Filter Pump Relay

Aux. 3 Relay

To Breaker

Panel

120 VAC

Filter Pump Relay

Aux. 3 Relay

To Breaker

Panel

Wiring Power Pack to an AquaLink RS

or PDA Power Center (240 VAC and 120

VAC)

4 3 2 1

OPTIONAL

Jandy

Power Center

Communication Wiring between Power

Pack and AquaLink

or PDA Network

To Power Pack

(240 VAC)

To Power Pack

(120 VAC)

Power Pack

GRN

YEL

BLK

RED

RS Control System