Gardena 4051 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gardena 4051. Gardena 4051 12 pagina's. Petrol lawnmower

Pagina afdrukken

Filling the engine with

engine oil:

See the enclosed engine

operating instructions.

1. Unscrew the oil cap

2. Fill with approx. 0.6 l engine

oil (SAE 30) (OIL).

3. Screw the oil cap

46 VDA / 51 VDA

Filling the engine with petrol:

See the enclose engine operating instructions.

1. Undo the petrol cap

2. Fill with petrol (at least 87 octane) (FUEL).

3. Do the petrol cap

For further engine maintenance instructions see the

enclosed engine operating instructions.

Cleaning the mower housing:

Deposits make the starting process difficult, impair the quality

of the cut and the discharge of the grass. Dirt and grass

residues are easiest to remove immediately after mowing.

The bottom should be cleaned on the grass to avoid getting

the ground dirty.

1. Remove the mulch unit / collecting bag.

2. Fit the hose connection

3. Start the mower and switch off again after about 30 seconds.

The rotating blade bar throws the water onto the bottom of the

mower and thus cleans it.

4. Turn off the tap and remove the hose connection

5. Clean the top with a cloth (do not use any sharp objects).

Cleaning the collecting bag:

The collecting bag must be checked regularly for damage.

v Remove grass deposits from inside and outside the collecting

bag at every mowing (do not use sharp objects).

Cleaning the mulch unit:

v Immediately after mulching remove dirt and grass remains

from the mulch unit (do not use any sharp objects).

ATTENTION!

Damage to the engine!

v The engine must be filled with oil before starting.

on again.

46 V / 51 VD

up again.

to the mower and turn the tap on.

8. Trouble-Shooting

Adjust Bowden cable of the

If the Bowden cable of the drive has moved due to wear, it can

drive:

be adjusted.

v Turn the adjusting nut

relevant direction (+/–).

46 VD:

The adjusting nut is located on

the left-hand handle

46 VDA / 51 VDA

Adjust Bowden cable of the

46 VDA / 51 VDA:

switch handle:

If the Bowden cable of the switch handle

wear, it can be adjusted.

1. Detach attachment hook

2. Insert attachment hook

46 VDA / 51 VDA

Replacing the blade bar:

A damaged or bent blade bar or a blade bar with broken off

edges must be replaced because of the imbalance this

causes. For imbalance reasons the blade bar must not be re-

ground.

DANGER!

Danger of physical injury from the blade bar!

v Before remedying faults wait for the blade bar

to stop, wear suitable working gloves and

remove the spark plug connector (see enclosed

engine operating instructions).

in the

46 V

has moved due to

into hole 1 of the switch handle

Blade bars must only be replaced by GARDENA

service department or by an authorised GARDENA

dealer.