KitchenAid KGBS 146S Handleiding voor installatie-instructies - Pagina 5

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid KGBS 146S. KitchenAid KGBS 146S 11 pagina's. Gas built-in single & double ovens

Pagina afdrukken

INSTALLING

THE UNIT IN CABINET

Route electric

supply

cord so that it can be plugged

into

receptacle

after unit has been slid into place in cabinet.

Potential Personal Injury

Use both hands to remove oven doors.

Grasp only the sides of the oven door. Do Not use any

portion of the front frames or trim for lifting.

Failure to properly grasp oven door could result in

damage to product or personal injury.

The doors should

be removed

to decrease

the weight of the

oven and provide a better hand hold on the oven while lifting

it into the cabinet.

TO REMOVE

DOORS (See Illus.)

Use caution!

Oven door is heavy.

1. Open door completely.

2. Depress

finger tab in oven door hinge area. Push tab

toward oven. Lift tab away from door liner and slide toward

top of oven door.

3. Repeat step 2 for other side of door.

4. Close door until approximately

5 inches from fully closed

position.

5. Slide door off the hinge arm assemblies.

6. Repeat steps 1 through 5 for other door on double ovens.

BE SURE THAT

MICA SPACERS AT EITHER SIDE OF OVEN

ARE IN PLACE TO PROVIDE PROPER AIR FLOW BETWEEN

CABINET

AND OVEN.

When oven has been placed into cabinet, the bottom trim strip

is placed on the lower edge of the front frame. This is done

by loosening

the three screws at the bottom of the front frame.

Place gas valve extension

rod through

hole in trim strip and

slide strip under screw heads until the top edge of trim meets

the lower corners of the front frame (see Illus.). Tighten screws

to hold trim to front frame. Make sure that valve is turned to

the full "on"

position

(pin straight

and down).

Personal Injury Hazard

Securely fasten wall oven to cabinets using the screws

provided (4 screws for a double oven or 2 screws for a

single oven).

Failure

to do so could cause oven to move

tip during

use and result in personal injury.

Secure oven to cabinet with #8 screws provided.

Do not

overtighten

screws. Edge of front frame should be parallel

to cabinet. Disregard any excess screws that are left after

all screw holes in front frame have been used.

B. REPLACE

OVEN RACKS IN OVEN CAVITY.

C. REINSTALL

THE DOOR(S)

(See Illus.)

DOOR REMOVE

FINGER TAB

1. Slide door hinge arms until firmly seated.

2. Lower door to full open position.

3. Push finger tabs to back. Depress

the tabs and slide forward.

4. Close and reopen door slowly to make sure it has been replaced

properly.

5. Repeat steps 1 through

4 for other door on double

oven.