Gardena 10000 SL Inox Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gardena 10000 SL Inox. Gardena 10000 SL Inox 11 pagina's.

Pagina afdrukken

Manual operation :

Only for 10000 SL Inox :

Flat suction /

Normal operation

Adjusting the Cut-in and Cut-out Height :

The maximum cut-in height and minimum cut-out height (see

8. Technical Data) can be adjusted.

v Press the cable of the float switch

switch lock

Do not select a cable length that is too long or short to ensure

that the float switch can turn on and off properly.

• The higher the opening of the float switch lock

the cut-in and cut-out height.

• The shorter the length of cable between the float switch

and the float switch lock

higher the cut-out height.

The cable length between the float switch

lock

must always be at least 10 cm.

The pump remains in constant operation because the float switch

is bypassed.

1. Push the float switch

cable downward.

2. Stand the pump on a firm surface

– or –

use a rope attached through the bore hole in the carrying

handle

3. Plug the power cable

The residual water height (approx. 1 mm for 10000 SL Inox /

40 mm for 18000 SP Inox) is only reached during manual opera-

tion since the float switch turns off the pump during automatic

operation before this water level is reached.

V If the water height is lower than 3.5 cm, fill the pump

before operation over the universal fitting

Flat suction :

v Turn the 3 swivel feet

180° to 1 mm.

Flat suction up to 1 mm.

The residual water level of approx. 1 mm is only reached during

flat suction in the manual operation mode. If the water level is

lower than 25 mm, you can accelerate flat suction by switching

the pump off and on 2 to 3 times.

, the lower the cut-in height and the

onto the float switch lock

to immerse the pump in a well or shaft.

into a mains socket.

into an opening in the float

, the higher

and the float switch

with the

with water.

Normal operation :

v Turn the 3 swivel feet

180° to 5 mm.

Flat suction up to 5 mm.