Gardena 1438 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gardena 1438. Gardena 1438 14 pagina's. Garden pump

Pagina afdrukken

Location

Caution: Pursuant to DIN VDE 0100-702 and

0100-738 use of the pump nearby swimming

pools and garden ponds and other similar

places is only permissible if the pump is oper-

ated via a residual-current device (FI switch)

with a residual current rating of ≤ 30 mA. The

pump must be located on solid, even ground,

protected from flooding. Take care that the

pump cannot fall into water. As an additional

safety device an authorised safety switch can

be used.

v Please ask your electrician for his advice.

The pump must not be operated when there

are persons in the swimming pool or garden

pond.

A Pump Preliminary Filter, Art. 1730 / 1731,

should be used to prevent foreign bodies

damaging the turbine.

Extension cables

Pursuant to DIN VDE 0620, power cable as

well as extension cables must not have a

smaller diameter than rubber sheathed cables

described with letter symbols H07 RNF.

v Don't use the power cable for carrying the

pump or for plugging off.

In Austria

In Austria, the electrical connections must be

made according to ÖVE-EM 42, T2 (2000) /

1979 § 22 based on § 2022. Pursuant to this

regulation it's imperative to operate pumps for

swimming pools and garden ponds exclusively

via an isolating transformer.

v Please ask your electrician.

In Switzerland

In Switzerland mobile appliances which are

used outdoors, must be connected via a

residual-current device.

Environment

v Protect the pump from rain. Don't use the

pump in wet or moist area.

Visual check

v Before operating the pump, first make a

visual cheek, if there is any damage of the

pump (esp. regarding power cable and

plug).

A damaged pump must not be used.

v In case of damage, please have the pump

checked by our GARDENA Service Centre

or by an authorised electrician.

Check line voltage

Date indicated on the type plate must match

technical data of the mains supply.

Dry-Running

In order to avoid dry-running of the pump, take

care that the end of the suction hose is always

submerged into the liquid.

v Before each operation, fill the pump to

overflowing with approx. 2 to 3 l of the

liquid to be pumped!

Liquid fails to flow

Sand and other abrasive substances in the

liquid cause in-creased wear and reduce the

pump's output.

v Use a pump preliminary filter for pumping

sandy liquids.

Pumping dirty water, e.g. stones, pine needles

etc., can cause damage to the pump.

v Do not pump dirty water.

Hot water – risk of scalding

If the pump is operated for prolonged periods

of time (> 5 min) with the delivery side closed,

the water in the pump may heat up so that

there is a risk of scalding yourself with hot

water.

v The pump should not run against the

closed delivery side for more than

5 minutes.

v If liquid fails to flow, switch off the pump

immediately.

Minimum flow rate

The minimum flow rate is 80 l / h (= 1.3 l / min).

Watering accessories with lower rate must not

be operated.