Gardena 4000/2 automatic 1742 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gardena 4000/2 automatic 1742. Gardena 4000/2 automatic 1742 10 pagina's. Rain water tank pump
Ook voor Gardena 4000/2 automatic 1742: Gebruiksaanwijzing (9 pagina's), Gebruiksaanwijzing (14 pagina's), Gebruiksaanwijzing (9 pagina's), Gebruikershandleiding (10 pagina's)
Pagina afdrukken
v Press the cable of the float switch
lock
>
.
In order to ensure that the float switch is able to switch on and off, the
cable length between the float switch and the float switch lock must be
at least 10 cm.
4000/2 automatic (Art. 1742):
Automatic mode:
The pump automatically switches off as soon as no more water is
retrieved. Due to the non-return valve, the pressure is maintained in the
hose until water is drawn via the hose. When water is drawn via the
hose (the pressure in the hose falls below approx. 1.3 bar), the pump
switches on automatically.
Dry-Running Safety:
When there is no liquid to pump, the pump automatically switches off.
The pump then switches in the cycle on 30 sec. – 5 sec. off (4 x). In 1 hr.,
5 hrs., 24 hrs., 24 hrs.... this cycle is repeated. As soon as the pump
stands in at least 4.5 cm water, the pump is ready for operation again.
Leakage protection:
If there is leakage on the pressure side (e. g. a leaking pressure hose or
connecting device), the pump automatically switches on and off in short
intervals. When the pump switches on and off more frequently than 7 x in
2 min. (with a leakage less than 90 l/h), the pump switches completely off.
When the leakage on the pressure side is eliminated, the pump must be
unplugged and plugged in again in order to be operational again.
4. STORAGE
To put into storage [ Fig. S1 / S2 ]:
The product must be stored away from children.
The pump must be protected against frost.
1. Unscrew the telescopic lance
upside down).
2. Store the pump in a dry, frost-proof location.
Transport position:
1. Unscrew telescopic pipe
3
and attach to the side of pump.
<
Here, ensure that the nose
6
2. Wind mains cable
around the cable holder
connector
4
.
In the transport position, the pump can be carried by the telescopic
pipe
3
. For easier winding of the mains cable
0
of the cable holder
.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household waste.
It must be disposed of in line with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
5. MAINTENANCE
Clean filter [ Fig. M1 ]:
DANGER! Electric shock!
There is a risk of injury from electric shocks.
v Before maintenance, unplug the Rain Water Tank Pump from
the mains.
In order to ensure continuous trouble-free operation, the filter
be cleaned at regular intervals.
After pumping dirty water, the filter must be cleaned immediately.
1. Press the two locks
1
and remove the foot
2. Turn filter
w
1/4 to the left and remove (bayonet lock).
3. Clean filter
w
under running water.
w
4. Re-install filter
in the opposite sequence.
8
9
into an opening in the float switch
3
and empty the pump (turn the pump
y
is slid into the slot
.
0
and the pump
6
, push up the slide bar
w
should
2
from the pump.
6. TROUBLESHOOTING
DANGER! Electric shock!
There is a risk of injury from electric shocks.
v Before correcting functional problems unplug the Rain Water
Tank Pump from the mains.
Problem
Possible Cause
Pump is running,
Air cannot escape, because the
but doesn't deliver
pressure line is closed. (Possible
kink in the pressure hose.)
Air in suction foot.
Foot / Suction foot / Filter is clog-
ged.
Water level below minimum
water level when put into
operation.
Pump does not start,
Thermal switch has turned
or stops suddenly during
the pump off because of
operation
overheating.
Pumping without electricity.
Pump is running but the
Foot / Suction foot / Filter is
delivery drops suddenly
clogged.
Only with 1742:
Leakage protection activated
Pump irregularly switches
due to leaking.
on and off
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.
7. TECHNICAL DATA
Rain Water Tank Pump
Unit
Rated Power
W
Max. delivery capacity
l/h
Max. pressure /
bar / m
Max. delivery head
q
Max. submersion depth
m
Cut-in height without/
with upper lock/
cm (approx.)
with lower lock
Cut-out height without/
with upper lock/
cm (approx.)
with lower lock
Switch-on pressure
bar
(approx.)
Minimum water depth
cm
for operation (approx.)
Power cable
m
Weight without cable
kg
(approx.)
Max. media temperature
°C
Mains voltage /
V (AC) / Hz
Mains frequency
8. SERVICE / WARRANTY
Service:
Please contact the address on the back page.
Warranty:
In the event of a warranty claim, no charge is levied to you for the services
provided.
GARDENA Manufacturing GmbH offers a two-year warranty (effective as
of the date of purchase) for this product. This warranty includes all signifi-
cant defects of the product that can be proved to be material or manufac-
Remedy
v
Open the pressure line
(e. g. shut-off valve,
delivery units).
v
Wait for about max.
60 seconds until the pump
has vented; if necessary,
turn off and then on again.
v
Unplug at the mains
and clean filter
(see 5. MAINTENANCE).
v
Submerge the pump deeper.
v
Unplug at the mains
and clean filter
(see 5. MAINTENANCE).
Observe max. media
temperature (35 °C).
Check fuses and electrical
v
plug connections.
v
Unplug at the mains
and clean filter
(see 5. MAINTENANCE).
v
Check telescopic tube, hose
and dispensing device and
remove leakage.
Value (Art. 1740)
Value (Art. 1742)
500
500
4.000
4.000
2,0 / 20
2,0 / 20
7
7
70 /
34 /
–
32
21,5 /
14 /
–
12
–
1,3
4,5
4,5
10 H05RN-F
10 H05RN-F
4,8
5,0
35
35
220 – 240 / 50
220 – 240 / 50