Gardena GP 3000/4 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gardena GP 3000/4. Gardena GP 3000/4 10 pagina's. Garden pump
Ook voor Gardena GP 3000/4: Gebruikershandleiding (10 pagina's), Gebruikershandleiding (11 pagina's)

Pagina afdrukken

Pollution of the liquid could occur due to leakage of lubricants.

Circuit breaker

Thermal protection switch:

In the event of an overload, the pump is switched off by the built-in thermal motor

protection. After sufficient cooling of the motor, the pump is operational again.

Additional safety warnings

Electrical safety

DANGER! Cardiac arrest!

This product makes an electromagnetic field while it operates. This

field may under some conditions interfere with active or passive medical

implants. To decrease the risk of conditions that can possibly injure or

kill, we recommend persons with medical implants to speak with their

physician and the medical implant manufacturer before you operate the

product.

Cables

If extension cables are used, these must comply with the minimum cross-

sections in the table below:

Voltage

Cable length

230 – 240 V / 50 Hz

Up to 20 m

230 – 240 V / 50 Hz

20 – 50 m

DANGER! Electric shock!

Risk of injury due to electric current.

v Disconnect the product from the mains before you put it into storage,

maintain or troubleshoot.

The pump must be located on solid, even ground, protected from flooding. Take

care that the pump cannot fall into water. Position the pump at a safe distance

(min. 2 m) from the liquid to be pumped. As an additional safety device an

authorised safety switch can be used.

v Please ask your electrician for his advice.

If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

Protect the mains plug and the mains power cable from heat, oil and sharp

edges.

Do not use the power cable for carrying the pump or for unplugging.

Protect the pump from rain. Don't use the pump in wet or moist areas.

Please regularly check the connecting line.

Before using, always subject the pump (especially the power cables and the

power connections) to a visual inspection.

A pump which is damaged must not be used. In the event of damage, have the

pump checked by GARDENA Service.

When using our pumps with a generator, the warnings of the generator manufac-

turer must be observed.

Personal safety

DANGER! Risk of suffocation!

Small parts can be easily swallowed. There is also a risk that the poly-

bag can suffocate toddlers. Keep toddlers away when you assemble the

product.

DANGER! Risk of injury due to hot water!

If the pump is operated for prolonged periods of time (> 5 min.) with the

delivery side closed, the water in the pump may heat up so that there is

a risk of scalding yourself with hot water.

v The pump should not run against the closed delivery side for more

than 5 minutes.

If the water supply on the intake side of the pump fails, the water in the

pump can heat up so that if water emerges, injuries could be caused by

the hot water.

v Disconnect the pump from the mains via the main circuit breaker,

let the water cool and secure the suction-side water supply before

putting into operation again.

When connecting the pump to the water supply system, the country-specific

sanitary regulations must be observed to prevent water not of drinking water

quality being drawn back in.

v Please consult a specialist for sanitary installations.

In order to avoid dry-running of the pump, take care that the end of the suction

hose is always submerged into the liquid.

v Before each operation, fill the pump to overflowing with approx. 2 to 3 l of the

liquid to be pumped!

Sand and other abrasive substances cause increased wear and reduce the

pump's output.

v Use a pump pre-filter for pumping sandy liquids.

Pumping dirty water, e.g. stones, pine needles etc., can cause damage to the

pump.

v Do not pump dirty water.

2. ASSEMBLY

v Disconnect the product from the mains before you assemble

To set up the pump:

The site must be firm and solid in order to ensure safe and sturdy operat-

ing conditions for the pump.

v Position the pump at a safe distance (min. 2 m) from the water.

The pump must be installed in a location with low air humidity and suffi-

cient ventilation in the area of the ventilation slots. It must be at a distance

of at least 5 cm from the walls. Dirt (e. g. sand or soil) must not be sucked

in through the ventilation slots.

The plastic connection pieces on the intake and delivery sides may

only be tightened by hand.

Cross section

To connect the hose to the suction side [ Fig. A1 ]:

Don't use any hose quick connection system fittings on the suction side!

1.5 mm

v A vacuum-resistant suction hose must be used, e. g. GARDENA

2.5 mm

Suction Unit, Art. 1411 or GARDENA Bore Hole Suction Hose

Art. 1729.

In order to reduce the suction time, it is advisable to use a suction hose

with backflow preventer avoiding automatic draining of the suction hose

when the pump has been switched off.

1. Screw the pump connection piece

side

2. Connect the vacuum-resistant suction hose

connection piece

3. For suction heights exceeding 4 m: Also fix the suction hose

(e. g. by fastening it to a wooden post).

This relieves the pump of the weight of the suction hose.

To connect the hose to the pressure side [ Fig. A2 ]:

The pump connection

thread.

E. g. a GARDENA pump connection piece Art. 1745 is required for

the GARDENA Connection System (included in scope of delivery).

19 mm (3/4") / 16 mm (5/8") and 13 mm (1/2") hoses can be connected

via the GARDENA Connection System.

Hose diameter

13 mm (1/2")

16 mm (5/8")

19 mm (3/4")

Optimised use of the pump capacity is achieved by connecting

19 mm (3/4") hoses with e. g.

– GARDENA Pump Connection Set Art. 1752,

or by connecting 25 mm (1") hoses with

– GARDENA Quick Thread Coupling with external thread Art. 7115 /

Quick Coupling Hose Connector Art. 7103.

1. Only for Art. 9014: Use sealing tape

pump connection piece.

2. Screw the pump connection piece

side

3. Connect the pressure hose

If more than one hose /accessory is connected simultaneously, we

recommend using the

– GARDENA 2- or 4-Channel Water Distributor Art. 8193 / 8194,

GARDENA Twin-Tap Connector Art. 940

which can be screwed directly onto the pump connection piece

3. OPERATION

DANGER! Risk of injury!

Injury when the product starts accidentally.

the product.

(1)

(2)

of the pump.

(4)

is equipped with a 33.3 mm (G 1") internal

Pump connection

GARDENA Pump Connection Set

GARDENA Tap Connector

GARDENA Hose Connector

GARDENA Pump Connection Set

(4)

(5)

to the pump connection piece

DANGER! Risk of injury!

Injury when the product starts accidentally.

(2)

into the connector on the suction

(3)

airtight to the pump

(3)

Art. 1750

Art. 18202

Art. 18216

Art. 1752

(P)

on the external thread of the

(2)

into the connector on the delivery

(2)