Cosatto HUGO COT Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Cosatto HUGO COT. Cosatto HUGO COT 16 pagina's.

Pagina afdrukken

cot assembly

1 – attaching the fixed side

Attach the fixed side

opposite side to the fixed side. Insert 2 of the short bolts

the threads in the cot end. Loosely assembly - do not tighten.

Repeat with the other cot end (2).

2 – fitting the mattress base

Carefully turn the cot on its side and place the mattress base

Choose the preferred mattress base height - 3 options.

Place the barrel nuts

barrel nuts holes with the screw holes. Fit the long bolts

into the barrel nuts. Loosely assemble - do not tighten.

3 – fitting the drop side 1

Fit the runner screws

There should be movement in the cot as the bolts have not been tightened yet.

Attach the drop side

top of the slot in the cot ends.

4 – fitting the drop side 2

Allow the pins on the drop-side to rest against the cot ends.

Lift the drop-side 'W' until the pins are within the area 'X' in the channels. Press in the spring loaded

pins 'Y'. Protect the surface of the cot by using a screwdriver or a similar flat object and gently push the

lower part of the drop-side inwards 'Z' until the pins spring out and locate in the channel.

To complete the construction process, tighten ALL bolts.

5 – lowering the drop side

Lift the drop side.

Push the bottom edge inwards.

Lower the drop side.

6 – raising the drop side

Fully lift the drop side.

Push the bottom edge outwards.

Lower, ensuring both bottom corners are engaged.

7 – drop side removal

Loosen all the screws holding the cot ends to the fixed side and the mattress base.

Adjust the position of the drop-side until the pins align with the channel near the centre of the track.

Pull the drop-side forward and then down. This will push the spring loaded pins in so that the

drop-side can be removed from the track.

Protect the surface of the cot by using a screwdriver or a similar flat object to keep the pin in place.

(3)

to one of the cot ends (1). Ensure that the drop side mechanism is on the

(C)

into the bottom of the mattress base. Use a flat end screwdriver to align the

(D)

to each end of the drop side.

(5)

to the cot ends. Insert the head of the runner screws on the drop side into the

(A)

through the end of the cot side and into

(4)

in position.

(B)

into the holes in the cot ends and screw