Makita 6016 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Makita 6016. Makita 6016 8 pagina's. Drill
Ook voor Makita 6016: Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

OPERATION

CAUTION:

Before plugging in the tool, always check to see

•

that the switch trigger actuates properly and

returns to the "OFF" position when released.

Drilling operation

013438

Always use the top or back grip (auxiliary handle) and

firmly hold the tool by top or back grip and switch handle

during operations.

Drilling in wood

When drilling in wood, the best results are obtained with

wood drills equipped with a guide screw. The guide

screw makes drilling easier by pulling the bit into the

workpiece.

Drilling in metal

To prevent the bit from slipping when starting a hole,

make an indentation with a center-punch and hammer

at the point to be drilled. Place the point of the bit in the

indentation and start drilling.

Use a cutting lubricant when drilling metals. The

exceptions are iron and brass which should be drilled

dry.

CAUTION:

Pressing excessively on the tool will not speed up

•

the drilling. In fact, this excessive pressure will

only serve to damage the tip of your bit, decrease

the tool performance and shorten the service life

of the tool.

There is a tremendous twisting force exerted on

•

the tool/bit at the time of hole breakthrough. Hold

the tool firmly and exert care when the bit begins

to break through the workpiece.

Always secure small workpieces in a vise or

•

similar hold-down device.

Avoid drilling in material that you suspect contains

•

hidden nails or other things that may cause the bit

to bind or break.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

013436

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers,

always using Makita replacement parts.

1. Limit mark

1. Brush holder

cap

2. Screwdriver